Results 1 to 5 of 5
Thread: 5.3 bore
-
05-05-2008, 06:22 PM #1Junior Member
- Join Date
- May 2008
- Location
- hendersonville
- Posts
- 3
flat black- 1953 business coupe
5.3 bore
how far can u bore it safe. its iron
-
05-06-2008, 04:43 PM #2Member
- Join Date
- Jun 2006
- Location
- DETROIT
- Age
- 46
- Posts
- 198
PEWTER- 99 TRANS AM
3.905 Max
-
05-06-2008, 06:32 PM #3Junior Member
- Join Date
- May 2008
- Location
- hendersonville
- Posts
- 3
flat black- 1953 business coupe
man I was hoping to go 2 a conventional 4.000 bore
-
05-06-2008, 07:11 PM #4Junior Member
- Join Date
- May 2008
- Location
- hendersonville
- Posts
- 3
flat black- 1953 business coupe
how big of a stroke will fit in it
-
05-17-2008, 01:16 PM #5Member
- Join Date
- Jun 2006
- Location
- DETROIT
- Age
- 46
- Posts
- 198
PEWTER- 99 TRANS AM
4.00" will drop in with a little grinding. 4.25" will go with lots ($500-$700)of machine work.
Run the 3.905 bore with 4.00 crank for a 383cuin 15* small block. With the right cam and mild ported heads will easily make 500+HP.Dont be afried of the small bore the difference is only a couple of HP's.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Question: hub center bore
By 98TransAmWs-6 in forum Wheels and TiresReplies: 2Last Post: 06-03-2012, 05:51 PM -
Question: How much to bore?
By farmer_ron_99 in forum Internal EngineReplies: 2Last Post: 08-04-2009, 08:51 AM -
Max bore on iron 6.0l
By crankshaft in forum Internal EngineReplies: 6Last Post: 06-04-2009, 10:31 AM -
Max bore on 6.2l?
By 99transamC/FIA in forum General HelpReplies: 0Last Post: 08-14-2008, 01:35 PM -
bore
By 01tao6gto in forum Internal EngineReplies: 2Last Post: 11-15-2007, 09:30 PM
Bookmarks