throttlebody spacer

**FreakV6** · 08-05-2006, 11:03 PM

i just got mine in and am ready to install it. the spacer come with three threaded studs. on the car their are two threaded studs and one bolt that goes in at the top. do i just need to but a nut to go on the third stud or am i missing something. its seems like that bolt would be a lot bigger in diameter then the stud. so has anyone got one of these from zzp? if so what gives? oh by the way this is on a 01 3.8.....one more quick thing, does a whipser lid need to be modified in order to run this spacer? thanks in advance, forrest.

**sunsetorangess** · 08-08-2006, 02:59 PM

Shouldnt need too touch the lid, the flex pipe should make up for the extra room. Why are you adding a tb spacer? I would use the two studs and then use the orignal third bolt too hook it up.
J

**FreakV6** · 08-09-2006, 04:35 PM

pretty much adding it to say i have most every bolt on possiable. the only problem with reusing the bolt is it wouldnt be long enough any more.

**sunsetorangess** · 08-13-2006, 04:59 PM

Sounds like a trip too a local parts store is inorder for ya. Pick up a long enought bolt too make it work, just make sure its the same thread and not too long...
If you want my op. just save the hassle and dont waste your time bc you wont see any gains.
goodluck thou
J