suspension

**o2 double s camaro** · 07-27-2009, 07:54 AM

Im thinking of doing some suspension work such as subframe connectors,lower control arms, and panhard bar from UMI. I also want to put the Eibach prokit springs on. I was wondering if you have to change the shocks for the prokit. my car has a magnaflow cat back, slp cold air, and nitto 555r drag radials my next question is with that suspension set up what do you guys think it will run in the quarter (m6).

**02Sweet** · 07-27-2009, 08:15 AM

Originally Posted by o2 double s camaro

Im thinking of doing some suspension work such as subframe connectors,lower control arms, and panhard bar from UMI. I also want to put the Eibach prokit springs on. I was wondering if you have to change the shocks for the prokit. my car has a magnaflow cat back, slp cold air, and nitto 555r drag radials my next question is with that suspension set up what do you guys think it will run in the quarter (m6).

I would call up sam strano before putting those springs on. A lot of people like his springs better than eibachs

**vetteemt** · 07-27-2009, 08:20 AM

Originally Posted by 02Sweet

I would call up sam strano before putting those springs on. A lot of people like his springs better than eibachs

X2 Sam is the man!

Here is his website http://www.stranoparts.com/

**sunsetorangess** · 07-27-2009, 08:37 AM

I would start with a good set of Sub-Frame connectors. Weld in.
They will prevent the oh so common dimples in the rear...
J

**99yellowz28** · 07-27-2009, 09:10 AM

i have those springs and kyb shocks and struts plus the umi pan hard bar. you better get some good shocks because those springs are rough I don't drive down some roads now because of how bad it is call strano hes a good guy ive delt with him