Results 1 to 2 of 2
Thread: subframe connector help
-
08-15-2008, 08:25 PM #1
subframe connector help
I picked up a set of weld in SFC's from Sphohn peformance and i am looking to get some better Installation instructions than the ones they gave me. Im not able to use a drive on lift so my garage is where its ganna happen. The part i dont understand is how to not build a twist in the car, because i pritty shure the car has to be somewhat level when you do this, right? Spohn says to place the front tires on ramps and jack the rear end up. I know the car's suspension would be at load at that point but i afraid that the car could be uneven when i weld the SFC's in.
I really dont wanna screw my car up so can someone please give a step by step procedure if possible. thanks
-
08-16-2008, 01:58 AM #2
Having the front wheels on the ramps and the rear held up by jackstands is the same as it being on a lift, it will be fine. The suspension is still under the same load as it would be on a lift. Be sure to have the rear as high as the front if you want it to be perfectly level.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Question: Subframe Connector Info
By jcws6 in forum Suspension and HandlingReplies: 9Last Post: 10-17-2011, 07:55 AM -
Subframe connector question
By 02blckws6 in forum Suspension and HandlingReplies: 37Last Post: 10-20-2010, 02:57 PM -
Subframe Connector Question?
By camarostripes96 in forum LT1Replies: 1Last Post: 05-15-2008, 06:10 AM -
Subframe Connector ?
By fastfirebird2002 in forum Suspension and HandlingReplies: 5Last Post: 03-26-2008, 05:54 AM -
subframe connector
By uwilluz in forum Suspension and HandlingReplies: 16Last Post: 04-20-2006, 08:14 AM
Bookmarks