Results 1 to 5 of 5
Thread: Removal of trans mount bushing
-
12-30-2007, 06:16 PM #1
Removal of trans mount bushing
how do i remove the trans mount bushing for the torque arm??
-
12-30-2007, 06:47 PM #2
I believe there's 3 bolts total. One on top that holds the mount together as well as to the tranny and two side by side below the torque arm.
-
12-31-2007, 06:44 AM #3
Just soak them with PB blaster (or equivalent) a couple of days before you tackle it.
-
12-31-2007, 12:32 PM #4
Very good suggestion. I had a tough time removing mine
-
12-31-2007, 12:40 PM #5
i was under that car today putting in a new PHB. I saw where the rear end of the tranny is hitting the tunnel. I can flex the mount pretty good with just using my arm so i cant imagine what its doing when the engine torques it up. Ordered a bushing from a place that i dunno if i can say or not but it red and the stores intials are E.S. haha hope it will come soon
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
t56 trans mount bushing
By Ls_won in forum DrivetrainReplies: 1Last Post: 07-13-2011, 08:59 PM -
Pedders bushing removal
By Goatdriver in forum GTOReplies: 0Last Post: 08-26-2007, 06:23 AM -
lower a-arm bushing removal tips/help needed
By 2MuchFun in forum Suspension and HandlingReplies: 7Last Post: 08-20-2007, 04:58 PM -
lower a-arm bushing removal tips/help needed
By 2MuchFun in forum General HelpReplies: 0Last Post: 08-14-2007, 05:58 PM -
Pilot bushing Bearing Removal need suggestions
By Zak in forum Internal EngineReplies: 7Last Post: 08-10-2006, 04:22 AM
Bookmarks