Moser 9"

**BashamWS6** · 07-11-2011, 07:10 AM

Found this on craigslist. Local listing.
My car is a DD and so i will have to get it to work with abs and parking break.

Moser 9" p/c black but has had lca relos and BMR arb brackets welded on after the rear was completed so they aren't coated at all, just cosmetics obviously. Rear is STOCK WIDTH, TRU-TRAC DIF, 4.11's with about 2000 miles on them and is Quiet! Nodular center, 31 spline and will come with backing plates but is not set up for abs or parking brake. All you will need is your T'bolts. Also has 1/2" studs.

How does this sound? Thoughts? Suggestions? Is it ok to buy used?
Someday id like to go procharger and/or nos abd maybe upgrade to 243 heads

**ls1camino** · 07-11-2011, 07:22 AM

I bought my Moser 9" used, and my one word of advice is this: Get it rebuilt BEFORE you install it in the car...replace all the bearings (even if they look fine) and all of the seals. You'll thank me later.

**BashamWS6** · 07-11-2011, 11:52 AM

Whats needed to make it abs and enable the parking brake?

**ls1camino** · 07-11-2011, 12:51 PM

Originally Posted by BashamWS6

Whats needed to make it abs and enable the parking brake?

Not sure, I have neither.

**BashamWS6** · 07-12-2011, 05:42 AM

Apparently there is a kit. Id just forget the Traction control. But te ebrake has to be removed from the stocker and pressed on the new(to me) rear, then the kit would refab it to make it work... So this basically makes it a waste of time...