Results 1 to 1 of 1
  1. 01-12-2007, 07:42 AM #1
    AirMarcus
    AirMarcus is offline
    Junior Member AirMarcus's Avatar
    Join Date
    Sep 2006
    Location
    Bossier City, la
    Posts
    22

    RED
    01 Z28

    Where does it bleed?

    When bleeding the slave/t-out bearing on an 01 6-speed, where does the fluid go? Does it just drip out into the tranny? Will it contaminate my disc? Does the fluid come out of the post that the wrench goes on? If so is there a special tool to remove the fluid when turning the post? I have great instructions on how to repair and bleed the system but I just do not want to mess anything up in the bleeding process. Thanks for any help. I will report back after my master cylinder replacement with any problems or tips or brain damage. Thanks again, Mark.-I READ ON ANOTHER POST THAT THE FLUID WILL DRAIN OUT OF A RECTANGULAR HOLE AND TAKE CARE OF ITSELF.
    Last edited by AirMarcus; 01-14-2007 at 10:36 AM. Reason: ADDITION
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Question: clutch bleed
    By reaper ws6 in forum Manual Transmission
    Replies: 2
    Last Post: 06-17-2011, 08:26 AM
  2. is my clutch not bleed out right?
    By mikey gavin in forum Manual Transmission
    Replies: 0
    Last Post: 03-23-2011, 01:57 PM
  3. How to bleed the air
    By karpetcm in forum General Help
    Replies: 2
    Last Post: 01-19-2009, 04:04 PM
  4. How to bleed the clutch?
    By SteelmanLS1 in forum Manual Transmission
    Replies: 1
    Last Post: 08-22-2008, 06:38 PM
  5. How do you bleed brakes?
    By wicked illusions in forum General Help
    Replies: 6
    Last Post: 03-19-2006, 07:53 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules