This is a discussion on Issue within the Manual Transmission forums, part of the Drivetrain category; Ok. I decided to take my car for a little test spin today. Earlier this week I replaced the plugs ...
08-09-2008, 04:30 PM #1
I decided to take my car for a little test spin today. Earlier this week I replaced the plugs and wires.
I went to a secluded area and decided to spin the tires in first. I revved it to 3500 RPM and let out the clutch. And boy did they spin. At least 4 to 5 feet long marks.
My issue is the clutch didn't come back up. I had to use my left foot to get bellow the pedal to lift it backup. I did it a 2nd time and same issue.
I heard something about a drill mod. Could this help this?
08-30-2008, 11:06 AM #2
Do a search on the forum and you will see many similar issues. Apparently the slave cylinder design was changed in 01/02, so your's may not be as good as the new ones. Perhaps it would be better to flush your fluid first before getting into that though.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By hix5000 in forum General HelpReplies: 12Last Post: 05-21-2008, 05:58 AM
By 01SOMSS! in forum Western MembersReplies: 20Last Post: 04-09-2008, 06:24 AM
By 01SOMSS! in forum Appearance SectionReplies: 7Last Post: 04-07-2008, 09:16 PM
By calee4nyaboy in forum CorvetteReplies: 14Last Post: 10-06-2007, 07:35 PM
By dafizzman1 in forum External EngineReplies: 0Last Post: 07-22-2007, 03:08 PM