Clutch won't disengage - Throwout Bearing Install

[x10-wakerider]

I just replaced the throw out bearing and after vacuum bleeding it with a mighty vac the clutch still wont disengage. Could I have done something wrong during the install or do I need to keep bleeding? I did not bleed the throw our bearing because I was told it was pre-bleed. I used the link below for mighty vac bleeding instructions.

http://www.performanceworks1.com/ls1...h_bleeding.htm

[chuckunit69]

keep bleedin it took me 2 hours to bleed mine

[SMWS6TA]

keep bleedin it took me 2 hours to bleed mine

+1 same here, I was getting seriously pissed off, because I was thinking the master was bad and didn't want to have to pull it out to get another one...

[x10-wakerider]

I bleed it some more and that fixed it! Thanks!

[devildogws6]

wont disengage i had the same problem but with mine it was because two springs on my clutch broke!!!