This is a discussion on Clutch Problems within the Manual Transmission forums, part of the Drivetrain category; I have a 97-LT1 with 6 Spd. I have installed a Spec Clutch assembly. It's been in for about 9,000 ...
03-03-2008, 12:42 PM #1
- Join Date
- Mar 2008
- Palm Beach
- 1997 Z-28
I have a 97-LT1 with 6 Spd. I have installed a Spec Clutch assembly. It's been in for about 9,000 miles. I was sitting at the light out of gear. Went to put into gear and the pedal will only go part way and gets real hard. I forced it down enough to get into 2nd and limp it home. I attempted to bleed by pushing the slave rod in several times both short and long strikes. Only tiny bubbles is all that came up and it is still the same. Any Ideas? And is the master and slave all on assembly in the 97's?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Ed Blown Vert in forum CorvetteReplies: 0Last Post: 02-07-2008, 09:30 PM
By 7camaro7 in forum Manual TransmissionReplies: 21Last Post: 12-13-2007, 07:41 PM
By Nero.Jacinth in forum General HelpReplies: 0Last Post: 04-30-2007, 09:25 AM
By adam0321 in forum General HelpReplies: 2Last Post: 04-12-2007, 12:39 PM
By TurdBurglar1982 in forum Manual TransmissionReplies: 4Last Post: 10-07-2005, 03:42 PM