Am I missing something here?

[28Marcos]

the open hole, like a cap?
THis is on my belhousing on my 4l60e transmission:

[Ed Blown Vert]

I never noticed that on my housing. Hmm....

[bills98ta]

I think you're looking at the breather / vent.

[Benner]

I think you're looking at the breather / vent.

Breather vent isn't on the bell housing and that's a view of the bottom of the bell housing. Capped part is the inspection hole but I haven't the slightest clue on what that could be.

[bills98ta]

Breather vent isn't on the bell housing and that's a view of the bottom of the bell housing. Capped part is the inspection hole but I haven't the slightest clue on what that could be.

You're right. My PC didn't load that picture this morning when I looked at the thread... I think mine has a tin cover plate over it. It won't hurt any thing leaving it open.

[28Marcos]

It won't hurt any thing leaving it open.

cool cause ive had it like that for a couple of years lmao! i just always forget!
but i just started another thread in the general help section cause i just noticed something missing near my oil filter. and i would appreciate the help there too!
thanks all!

[SS SLP2]

hole is where I turn the fly wheel with a homemade tool or screw driver when unbolt/bolt converter.
I will try to draw a picture of tool, I use a peice of 1/4" x 1 1/2" x 18" long
flat bar with ^^^^^ at top to fit into fly wheel and a < ( notch ) in the side to hold the tool in the hole while inguaged in fly wheel.
Now I see if I can draw it
Johnny
edit ps: I can not draw it so that it will display the picture correct, it should be a flat bar abiut 1 1/2 wide.


l^^^^^^^l
l...............l
>..............l
l...............l
l...............l
l...............l

[c5z28]

subscribed

[bills98ta]

I usally turn the flywheel, by the balancer bolt on the front of the motor. Our bell housings are tighter than most.