Results 1 to 4 of 4
-
05-30-2010, 05:35 PM #1
RPMS all over the place after PP TB install
I bought a PP TB and at first when i installed it the car was idling at 3,000 RPM. After a quick look realized the hole to the butterfly was made bigger allowing more air so i replaced the butterfly for the stock one. Now the car idles at 1100 RPM and drives fine HOWEVER, when you shift or even engage the clutch the RPM jumps back up to 3000 but once you shift into gear the RPMs are normal. Any ideas?
-
05-30-2010, 06:59 PM #2
- Join Date
- Apr 2008
- Location
- Madison, WI
- Posts
- 7,006
1999 Formula WS6 M6-sold- 2001 Silverado Z71
make sure the idle screw is adjusted properly so that the TPS voltage is between .4 and .6 volts at idle.
-
05-30-2010, 07:19 PM #3
- Join Date
- Aug 2005
- Location
- cleveland ohio
- Posts
- 11,373
trans am 00 ws6- 1998 camaro ss vert
I WAS JUST DOING THIS ON MINE TONIGHT. SORRY caps.
i adjusted the screw a few time and it was better.
-
05-30-2010, 07:41 PM #4
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Good place for cam install and dyno tune?
By tg580 in forum General HelpReplies: 1Last Post: 04-19-2010, 08:02 PM -
best place to buy pro 5.0 SHifter/ hard install?
By 5abivt in forum DrivetrainReplies: 4Last Post: 05-10-2009, 02:44 PM -
4-5 RPMs!
By Too Fast in forum Stereo and ElectronicsReplies: 1Last Post: 11-04-2007, 06:41 AM -
anyone in philly kno of a good place to install LT headers
By Bandit1 in forum Eastern MembersReplies: 12Last Post: 07-31-2007, 11:56 AM -
rpms
By C5_LS1 in forum CorvetteReplies: 2Last Post: 02-01-2006, 05:31 AM
Bookmarks