new header ?
This is a discussion on new header ? within the External Engine forums, part of the LSx Technical Help Section category; I put a set of texas speed long tubes on my ta and I got it out for a run ...
02-14-2009, 01:45 PM #1
new header ?
I put a set of texas speed long tubes on my ta and I got it out for a run up the road yesterday and when i got back to the house i was looking it over and say that somthing had moved and they are rubing the steering shaft. has any one had this happen and have a way to fix it. i tryed to move the shaft a bit but its still to close for me.
02-14-2009, 03:47 PM #2
if you have access to a torch, you might beable to get the runner hot and gently felx it alittle out of the way......i have a torch, but im just lazy
02-15-2009, 08:08 AM #3
Did your Y pipe shift? all header bolts inplace?
J2001 SS, Its not the car its the Driver that matters....
02-18-2009, 08:26 AM #4
- Join Date
- Feb 2007
- chandler az
- 1999 camaro ss
mine is similar, my header hits just below the steering arm i believe its the crossmember, there is like a half an inch gap regularly and at wot or half throttle turning mine will rub it a couple times. i came to the conclusion that i need new motor mounts although i havent checked them yet. so good luck
thats my header!!!
02-18-2009, 12:14 PM #5
thanks guys im going to work on it this weekend some so i hope i can get it fixed. there was like 1/2 inch befor i got time to drive it so im hoping it easy to fix. i shold not need mounts i only have 13000 on the car so they should stilll be good.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Ed Blown Vert in forum Almost Anything GoesReplies: 0Last Post: 01-16-2009, 05:30 PM
By Ed Blown Vert in forum GTOReplies: 0Last Post: 12-18-2008, 04:50 AM
By Ed Blown Vert in forum Camaro / SSReplies: 0Last Post: 07-16-2008, 05:50 PM
By Transam7777 in forum General HelpReplies: 2Last Post: 08-31-2007, 05:28 PM