This is a discussion on little things within the External Engine forums, part of the LSx Technical Help Section category; I just got my kooks headers and am looking for a good gasket and bolts so that once they are ...
08-20-2007, 06:59 PM #1
I just got my kooks headers and am looking for a good gasket and bolts so that once they are on i dont haveto mess with them again. any suggestions?
08-20-2007, 07:00 PM #2
- Join Date
- Nov 2006
- Broken Arrow, OK
- 2000 Camaro SS
08-20-2007, 08:43 PM #305 PBM GTOCold Air Inductions CAI,Relocated IAT with omega,Slp Predator tune,Flowmaster axle back with H pipe,Custom tuned TCM.BC Racing coil overs
Sold 01 z28
08-21-2007, 04:28 AM #4
08-21-2007, 05:06 AM #5
I used Fel-Pro and a new set of GM bolts. Apply "torque strip" to the bolt heads after tightening so you can check to see if they are backing out from time to time.2000 Z28 M6, SLP Lid, SLP Bellows, SLP UD,
P&P Maf, TB By-Pass, PS Shorties, LS6 Intake, FAST 78mm TB, Hooker CB, Hurst Billet, Front Tower Brace, small 218/218....527/527....114 cam.
08-21-2007, 08:51 AM #6
a buddy aslo recomended fel pro, but those or gm i think would be good. Also would i need the "locking" header bolts i seen advertised.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By AKIRA in forum Almost Anything GoesReplies: 40Last Post: 03-09-2007, 07:02 PM
By Spaz in forum Almost Anything GoesReplies: 18Last Post: 03-02-2007, 05:01 AM
By 2001z in forum Parts For Sale / TradeReplies: 0Last Post: 10-24-2006, 05:02 PM
By viol8r in forum General HelpReplies: 3Last Post: 03-13-2006, 03:44 PM
By sassy in forum Almost Anything GoesReplies: 2Last Post: 02-22-2006, 08:44 PM