Results 1 to 4 of 4
-
06-10-2010, 11:49 AM #1
IAT Lid Hole Paddle drill bit size???
I bought an MTI aftermarket lid and I need to drill a hole for the IAT sensor. What size paddle drill bit do I need?? I have a 02 Pontiac trans am WS6.
-
06-10-2010, 11:52 AM #2
Also I still have the Rubber Grommet on there if that changes anything.
-
06-10-2010, 01:42 PM #3
The lid wasnt pre-Drilled?
If not i would just match it up, one size smaller than the grommet.
J2001 SS, Its not the car its the Driver that matters....
-
06-10-2010, 02:16 PM #4
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Paddle Shifter for the 4L60E
By MikeSomething in forum Automatic TransmissionReplies: 2Last Post: 05-22-2008, 05:48 PM -
size of trunk hole plugs?
By Raoul-Duke in forum GTOReplies: 5Last Post: 01-10-2008, 01:55 PM -
paddle shifters
By LT1 > LS1 in forum Automatic TransmissionReplies: 2Last Post: 01-09-2008, 07:34 PM -
4:10 and Paddle Pin Kit
By 89LX in forum Manual TransmissionReplies: 6Last Post: 12-26-2006, 08:54 PM
Bookmarks