Results 1 to 4 of 4
-
06-25-2008, 10:32 AM #1
I have dynatech should I go Kooks?
I have Dynatech Long Tube headers but they are not finished, should I take them off and go Kooks? I have them going to Dynatech Power Cats, and then to a borla cat back. What are your suggestions?
-
06-25-2008, 10:48 AM #2
- Join Date
- Mar 2007
- Location
- Gainesville, VA
- Posts
- 654
Personally I would not change them and spend the $$$ elsewhere unless they are rusting bad. All LTs are pretty close in power numbers and with the cost of Kooks you could buy quite a few other mods.
-
06-25-2008, 10:52 AM #3
- Join Date
- Mar 2006
- Location
- WI
- Posts
- 5,085
- Blog Entries
- 1
09 EclipseGT 75 Chevy 4x4- 2001 Trans-Am 13 F-XT
Seeing you have them installed run them until they are rusted out. Unless you want them to look good.
-
06-25-2008, 04:37 PM #4
What are your current primary tube size?
Also what mods do you have done to the motor?
You probably already have more than enough flow.
Is it a daily driver or a weekend warrior race car?
Need more info to answer your ? honestly.Don't be afraid of the bottle!!! Be afraid of your tune!!!
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Dynatech or QTP
By Bandit1 in forum External EngineReplies: 23Last Post: 02-22-2008, 03:05 PM -
Dynatech or QTP?
By Bandit1 in forum External EngineReplies: 0Last Post: 06-14-2007, 03:13 PM -
Dynatech 2.5" Cat
By 9t8z28 in forum Parts For Sale / TradeReplies: 5Last Post: 02-01-2007, 07:09 PM -
dynatech,kooks,stainless works headers
By skar in forum External EngineReplies: 8Last Post: 10-18-2005, 03:17 PM
Bookmarks