anybody running this magnaflow universal y pipe?

[emoFTW]

Hey was wondering if this universal y pipe was catted? anybody running this? are there small perforations on the inside like a resonator? or is it just straight through?

http://www.magnaflow.com/02product/s...e=main&id=8123

[emoFTW]

bump need peeps input please

[BlackSS1]

That is just a transition/joint pipe from two pipes to the singe Intermediate pipe. This is not a full y pipe - you would still need to make/fab pipes to the headers/cats to use this...

Unless you are making a full custom exhaust, pre-fabricated y-pipes are much easier.

[INMY01TA]

Yep what ^^ said.

[emoFTW]

^^^ yea man I'm making a custom Y pipe, just wanted to know if anybody was running this transition pipe, I was wonderin if it was straight through? or was it catted? Im looking for one that is stragiht through no cats.

[INMY01TA]

Cats dont attatch right to the merge. A cat alone would be bigger than that merge/transition pipe. So no there are no cats on that piece.

[Dewman]

i had it on my custom exhaust for my twin turbo stealth, it is essentially 2 pieces of stamped steel welded together.

[emoFTW]

ok good, i needed a piece exaclty like that to finish my exhaust! thanks guys!

[squee]

I would use the Flowmaster merge collector instead. It supposedly merges better. Kinda apparent if you look at em.

[emoFTW]

^^^ yea i actually just found the flowmaster one off of summitracing.com so im going with the flowmaster one.

where did you get yours from? and how much was it?

[squee]

My exhaust is stock right now except the STS turbo. I'm sell it and go with some ARH LT's and the Bassani stainless true dual setup, so no Y for me.