This is a discussion on Alt wiring within the External Engine forums, part of the LSx Technical Help Section category; Hey guys, It's been awhile since i posted i need to get back onto the LS1.com train lol so after ...
02-24-2012, 07:57 PM #1
It's been awhile since i posted i need to get back onto the LS1.com train lol
so after my motor swap, i was told during the tune that i had an alternator code. but it doesn't give me a dumb dumb light.
it charges fine and i don't know why its throwing a code.. does anyone have a diagram of how the wires go. i thought i had them back together the right way.. i did have to remove all the ground straps from the harness to get it out of the way. and again i thought i had them all back in the right spot, however that might not be the problem. its a new alternator. there was nothing wrong with the old one i just didn't want a beat ass ALT on my new motor,
02-25-2012, 03:31 PM #2
02-25-2012, 04:30 PM #3
do you have all your ground wires hooked up
02-25-2012, 07:24 PM #4
Check you wire that connects to the alt to the engine. Ita called the excite wire. Make aure its pluged in your alt ALL the way
02-27-2012, 08:18 AM #5
i know i didn't leave any of the grounds off, i made sure of that. when i get a chance i will double check all the wires on the Alt. does anyone have a diagram that would show the wiring?
02-27-2012, 08:36 AM #6
The back of any Haynes or Chilton manual should have them.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)