Results 1 to 4 of 4

timmys ta needs the masters

This is a discussion on timmys ta needs the masters within the General Help forums, part of the LSx Technical Help Section category; I just got a 99ta and i am trying 2 fig out when 2shift I spin all over with tcs ...

  1. #1
    Junior Member
    Join Date
    Nov 2005
    Location
    Trevose
    Age
    32
    Posts
    3

    Red
    1999trans am ram air

    timmys ta needs the masters

    I just got a 99ta and i am trying 2 fig out when 2shift I spin all over with tcs off and guys jump way out ahead with it on I no igot a sweet deal the sht thro shifter ihavent gotten used 2 so Ive grinded and it hurts like ****please help

  2. #2
    Detailing + Design third_shift|studios's Avatar
    Join Date
    Aug 2005
    Location
    Pittsburgh, PA
    Age
    35
    Posts
    21,719

    My life is a
    Ben Stiller movie.

    whoa..ok, i'm gonna try my best to figure out what you said.

    You have a manual LS1. You spin on launches and grind gears while racing?

    OK, don't rev up so high on launch. Get it up to about 1200-1500 and then drop the hammer. That should chirp the tires and get you moving forward. After about a half a second you should have the car in solid motion; go wide-open throttle.
    sometimes it helps to heat up the tires prior to a launch by doing a big ole burnout.

    Shift when you hit the rev limiter (6000) or:
    1st-2nd: 40mph
    2nd-3rd: 70mph
    3rd-4th: 95 mph
    4th-5th: 120mph

    when shifting, make sure you got that pedal all the way to the ground. if you have a high milaged 99, you could have a fried slave cylinder [the 01-02 transmissions/clutches/slaves were sooo much better] Do you grind when driving under normal conditions?
    Last edited by third_shift|studios; 12-10-2005 at 08:47 AM.

  3. #3
    Junior Member
    Join Date
    Nov 2005
    Location
    Trevose
    Age
    32
    Posts
    3

    Red
    1999trans am ram air

    thanks

    No not at all, just when im on it hard. i think when i take off and go for a gear its clutch in to the floor then by the time the shifter is in the middle my foot is off alittle. Then I go 4 it and it grinds its happend afew times and some times its all smooth.thanks 4 the mileage break down

  4. #4
    Detailing + Design third_shift|studios's Avatar
    Join Date
    Aug 2005
    Location
    Pittsburgh, PA
    Age
    35
    Posts
    21,719

    My life is a
    Ben Stiller movie.

    yeah, sounds like the issue is your pushing forward on the clutch, while the acceleration is pushing you back...sucks for short dudes [self included]

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Touring Car Masters - Bathurst Australia 2012
    By Firebug in forum Almost Anything Goes
    Replies: 15
    Last Post: 10-16-2012, 05:32 PM
  2. in celebration of the Masters...
    By Schmalgar in forum Almost Anything Goes
    Replies: 1
    Last Post: 04-08-2012, 06:11 AM
  3. Question: Help me my Xbox 360 masters :D
    By blackSS01 in forum Computers / Gaming
    Replies: 11
    Last Post: 11-17-2010, 01:56 PM
  4. Question for electronic masters!
    By blackSS01 in forum Almost Anything Goes
    Replies: 1
    Last Post: 08-02-2010, 01:41 AM
  5. Carolina Auto Masters
    By krusemj in forum Southern Members
    Replies: 23
    Last Post: 03-28-2008, 05:50 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •