Results 1 to 4 of 4

TCS Wont come back on after cam install help!!

This is a discussion on TCS Wont come back on after cam install help!! within the General Help forums, part of the LSx Technical Help Section category; Ok we just got done installing the cam about 2 weeks ago and since then the TCS light would com ...

  1. #1
    Awaiting Activation NeeD4SpeeD's Avatar
    Join Date
    Sep 2005
    Location
    New York, NY
    Posts
    1,720

    Collectors Edition Yellow
    2002 Pontiac Trans AM WS6

    Exclamation TCS Wont come back on after cam install help!!

    Ok we just got done installing the cam about 2 weeks ago and since then the TCS light would com eon with the car, but after i start it up, as soon as the airbag light would finish blinking the TCS off would automatically come on and i cant turn the TCS back on.....

    We've checked almost every possible thing including changing both sensors on the rear tires, checked all the sensors under the car and going into the rear, changed the abs module, tested the PCM, even tried to delete the code but would come back after 3 seconds and we used the GM master tuner computer module...still nothing... Tommorw were going to try and swap out the PCM with another 02 PCM and hope that works...if not i have absolutly no idea what it could be....

    It worked before we put the cam in but i didnt touch anything that could possible screw up the TCS.....

    Any suggestions would be greatly appriciated because i'm could to check again for the problem tommrow!!!

  2. #2
    Slow'er'Ass Mr. Luos's Avatar
    Join Date
    Aug 2005
    Location
    Thornton, CO
    Posts
    23,785

    Red Tint Jewelcoat
    2008 Trailblazer SS

    My best idea...
    TechII

    Although I hate the stealership as much as the next guy.
    2008 Trailblazer SS
    Yank PTB3600, Kooks 1 7/8" LT's, 4" intake, E-fans, Magnaflow, Sonnax kit, tranny cooler, tune.
    Lowered, HID's, tinted.

    1999 Pontiac Trans Am WS.6 #1747 SOLD
    531.1 RWHP 481.3 FT/Pounds all motor.

  3. #3
    Member keliente's Avatar
    Join Date
    Aug 2005
    Location
    Charlotte, NC
    Age
    31
    Posts
    723
    99 Firebird Formula

    Did you remove the module at the front of the engine bay for any reason (i.e. to get the cables out of the way?) The canister looking thing near the battery.

  4. #4
    Awaiting Activation NeeD4SpeeD's Avatar
    Join Date
    Sep 2005
    Location
    New York, NY
    Posts
    1,720

    Collectors Edition Yellow
    2002 Pontiac Trans AM WS6

    No the module wasnt moved at all.... believe it or not we found the problem... It was the damn PCM!!!!! Dont ask b/c i have no idea but it just must have been a freak timing thing because it was never touched and the battery was totally disconnected during the install so i guess it just went of natural causes....

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Cam install
    By marco in forum Internal Engine
    Replies: 4
    Last Post: 03-03-2006, 07:01 AM
  2. wont shift at WOT HELP! after cam install
    By ahowell3 in forum Automatic Transmission
    Replies: 1
    Last Post: 01-28-2006, 05:47 PM
  3. Cam, Springs, and LS6 Intake Install
    By Roastem in forum Internal Engine
    Replies: 6
    Last Post: 01-12-2006, 09:21 AM
  4. cam install question
    By baseballss in forum Internal Engine
    Replies: 4
    Last Post: 11-30-2005, 09:25 AM
  5. cam install cost?
    By delinquent543 in forum Internal Engine
    Replies: 7
    Last Post: 11-19-2005, 08:57 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •