This is a discussion on Rear Ends within the General Help forums, part of the LSx Technical Help Section category; Going to try to reuild my 10 bolt rear anybody got any sugestions on how to pull the axles? c ...
05-08-2010, 04:04 PM #1
Going to try to reuild my 10 bolt rear anybody got any sugestions on how to pull the axles? c clips? not sure how it goes together any suggestions would be greatly appreciated
05-08-2010, 04:52 PM #2
Not doubting your ability but i honestly would recommend you taking it to someone that has done it befor or have someone help you that has rebuilt one befor. If you dont set it up right it will eat itself alive within a few feet.
You dont have to remove the rear end inorder to replace the "guts".
Pull the drive shaft
Pull the tires and calipers.
pull the cover
Pull the pinioin lock bolt
Remove the pinion gear shaft
Push the flanged end of the axle into the housing inorder to access the "C clip"
If you have Trac control be careful when pulling the shaft not to damage the Reluctor wheel
Thats just a quick ramble if you want a little more detail drop me a pm with your email and ill send ya some info
J2001 SS, Its not the car its the Driver that matters....
05-09-2010, 11:22 AM #3
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By vannatte in forum DrivetrainReplies: 8Last Post: 05-04-2009, 08:07 PM
By Ed Blown Vert in forum Camaro / SSReplies: 0Last Post: 09-29-2007, 06:50 AM
By Anthracis in forum Camaro / SSReplies: 6Last Post: 04-13-2007, 05:18 PM
By SleeperZ28 in forum DrivetrainReplies: 3Last Post: 11-14-2005, 08:55 AM