QTP Cutouts Vrs McCord Power Plate

[2fast2blegal]

Hey so im stuck and dont know what to get
which one is better?????
the QTP cost around 400
and i cant figure out how much the McCord would cost.
help me out im a noob

[Ed Blown Vert]

I used the McCord

http://www.mccordcg.com/mpp/mpp.htm

[2fast2blegal]

ok but would this be all i need for the McCord or would there be more


Dual 3" MPP for Cutout ???

[Ed Blown Vert]

You would need to get a cut-out.

[2fast2blegal]

* 3" MPP for Borla - $117+ s/h
* Single 3" MPP for Cutout or Downpipe - $117+ s/h
* Dual 3" MPP for Cutout - $215+ s/h
* Single 2-1/4", 2-3/8", or 2-1/2" MPP for Cutout or Downpipe - $117+ s/h
* Dual 2-1/4", 2-3/8", or 2-1/2" MPP for Cutout - $215+ s/h




so which one is the cutout???

[Mr. Luos]

None of the above.

Cutout itself should be about $40-50.

[2fast2blegal]

ok the cut outs are 50 i should need 2 right??? and i need the motor
DC Gear Motor w/circuitry & mounting plate.
will i also need 2 ???

[2fast2blegal]

This is the order... will it work?
Dual Power Plates for 3" Cutouts
MPP2 3" Plate Only 2
MPP2 DC Gear Motor w/circuitry & mounting plate 2

is this enough or do i need more stuff

[Mr. Luos]

ok the cut outs are 50 i should need 2 right??? and i need the motor
DC Gear Motor w/circuitry & mounting plate.
will i also need 2 ???

You probably just want one cutout. Right after the y-pipe.