Plug Wire Question

**Badbird** · 07-24-2007, 12:46 PM

im looking to get new plug wires. im looking to get some that will stand up to the high heat of my headers on my LT1 TA. i currently have 8.5mm MSD wires. they are less than 1 year/10k miles old. and they are shot after my header install. and the do have the heat sheild on the ones closest to my headers. im looking at the accell wires. just dont want to do this again. its a royal pain in my ass.

**greatwhiteZ28** · 07-24-2007, 05:45 PM

doesnt msd make a header specic wires that can handel the heat, tryed looking at there site but it sucks

**greatwhiteZ28** · 07-24-2007, 05:46 PM

i do know that lots run msd s and taylors with headers with no problems. maybe taylors would be a good choice for you then

**0verkill** · 07-25-2007, 04:27 AM

i dont have the headers yet but i like my tayer 409 race wires if you go to summit racing that have them and talyer heat sealds in colers it ceaper to go thrue summit then the local auto parst stores for bout

**Tman** · 07-25-2007, 09:20 AM

I just used the Taylors and covered them wiht DEI heat shields. Been there for 2 years no problems

**9t8z28** · 07-25-2007, 09:45 AM

Originally Posted by Badbird

im looking to get new plug wires. im looking to get some that will stand up to the high heat of my headers on my LT1 TA. i currently have 8.5mm MSD wires. they are less than 1 year/10k miles old. and they are shot after my header install. and the do have the heat sheild on the ones closest to my headers. im looking at the accell wires. just dont want to do this again. its a royal pain in my ass.

The problem is you are running them under the headers. I had the same issue with the headers on my LT1. They are getting burned up as soon as you put them on. Get a custom wire kit from Taylor Vertex or MSD and run them on top. I know its hard doing this having a Opti-Spark but trust me, it works!

**Badbird** · 07-25-2007, 11:50 AM

im on a short time frame right now. can i run them how they are and wrap the wires is heat sheild? other wise where do i get the custom wire kit?

**9t8z28** · 07-25-2007, 06:24 PM

Originally Posted by Badbird

im on a short time frame right now. can i run them how they are and wrap the wires is heat sheild? other wise where do i get the custom wire kit?

It is harder to run them in the factory location. It is way easier to customize them. You will have to do a search cause its been more than 5 years since I did mine.