p0220 code

[new2dgame]

I have 99 T/A today I replaced my stock ls1 intake with a ls6 intake and fuel rail and inject,but now the car runs sluggish and the service engine light flashes while I'm driving a friend scan the car and code p0200 came up Can anyone tell me whats the prob and how to fix it?

[sutie]

(p0200-injector control circut voltage) make sure you have all the injectors seated fully, and that the wiring harness for each injector is attached correctly, fully seated, with retainer, and hooked to the correct injector. also trace the wiring harness for the injectors, make sure nothing got pinched in the swap.

your headline says P0220, just noticed it, so which code is it?

[JayTA98]

I have 99 T/A today I replaced my stock ls1 intake with a ls6 intake and fuel rail and inject,but now the car runs sluggish and the service engine light flashes while I'm driving a friend scan the car and code p0200 came up Can anyone tell me whats the prob and how to fix it?

that is related with the fuel injectors. Did you check the wires and wire harness for cuts or pinched wires? pull each plug to each injector and check the pins. make sure they are not bent. If you have an ohmeter read the resistance of each injector you could have one that is bad. plug them back and make sure that the conectors are going all the way in.

Did you tighten the bolts to specs?

was the fuel rail new? if it was old did you make sure there was no debris? the reason I ask is because it can clog one or more injectors.

[kingls1]

Try Google search, put in code and hit enter you will get a lot of information and possible fixes, My buddy at the auto parts checked mine and found a few(3) codes I did what he said(google) and problem fixed in no time..Bad fuse

[new2dgame]

that is related with the fuel injectors. Did you check the wires and wire harness for cuts or pinched wires? pull each plug to each injector and check the pins. make sure they are not bent. If you have an ohmeter read the resistance of each injector you could have one that is bad. plug them back and make sure that the conectors are going all the way in.

Did you tighten the bolts to specs?

was the fuel rail new? if it was old did you make sure there was no debris? the reason I ask is because it can clog one or more injectors.

The intake had injectors and a fuel rail on it (used injectors and rails)

[sutie]

then check all your wires. and check fuel pressure while your in there to make sure theres plenty of pressure at the rails.

[JayTA98]

then check all your wires. and check fuel pressure while your in there to make sure theres plenty of pressure at the rails.

+1 to this. you should have 58-60 psi at the fuel rail.

[new2dgame]

Can I jus put my ls1 fuel rail and injectors on the ls6 intake ??

[sutie]

Can I jus put my ls1 fuel rail and injectors on the ls6 intake ??

yes, they both attach the same way.

[JayTA98]

Can I jus put my ls1 fuel rail and injectors on the ls6 intake ??

yes you can. I have heard that the 98 injectors are bigger than the other years. you don't happen to know if they came out of a 98?

since you have yours, i will put your old fuel rail and injectors back. you don't know if there is an issue with the used set.

[new2dgame]

Fixed....the #7 injector wasn't plunged up

[JayTA98]

Glad you figure it out.

[new2dgame]

Glad you figure it out.

Thanks you guys (ls1.com) help me a lot