o2 sensors not hooked up after insall

[astyles]

i was just wondering where to look to see if they are plugged in.......the scanner says drivers side #1...

[0rion]

The plug comes in from above the K-member if I remember correctly. Should be pretty easy to check. Just look at the front O2 and see if it's plugged in or not.

[Redphoenix1998]

Very easy to check, you'll see the connector, just follow the sensor to the proper wire connector. If it is connected, might be the O2 is bad

[SSpdDmon]

Yup, the plug for the front driver's O2 sits on top of the k-member right next to the oil pan. You can get away with driving without O2 sensors for a little bit (yes - even the front ones). So, don't worry too much. I wouldn't do it too long though. But generally speaking, the tune from the factory comes rich enough to keep you safe.

[astyles]

thanks guys! i re-did the scan and it says bank 1 sensor 2 no activity.......so i'll make sure it is hooked up and if it is i guess i'll change it

[0rion]

bank 1 sensor 2 is your drivers side rear sensor and not the front.

[astyles]

cool i thought so

[astyles]

damn that back sensor is not easy to hook up! i finally had to use some hemostats to hold the plug still so i could plug it in.

[0rion]

Glad you got her all fixed up. Hmmmmm hemostats huh? I'm guessing you're not a doctor.

[astyles]

Glad you got her all fixed up. Hmmmmm hemostats huh? I'm guessing you're not a doctor.

lol.........hazy past