Results 1 to 16 of 16
Thread: Normal Idle
-
02-05-2008, 08:50 PM #1
Normal Idle
What is the normal idle of my T/A. Manual. it's about 800 as far as I can tell... is that what it should be?
-
02-05-2008, 10:40 PM #2
yeah its probably right my car normally idles just under 1000 rpms.
-
02-06-2008, 08:51 AM #3
- Join Date
- Dec 2007
- Location
- Arkansas/Missouri State Line
- Age
- 39
- Posts
- 331
Collector Yellow- 2002 Pontiac Trans Am CE
Mine idles @ 500rpm with a lope.
-
02-06-2008, 01:51 PM #4
so if mine is idling steady at 800 rpm what could be the issue? should i tune or maybe fix the idle screw... any idea where that is??
-
02-06-2008, 05:33 PM #5
Are you sure theres a problem? It doesn't seem like a bad idle.
-
02-06-2008, 05:48 PM #6
mine idles right at 1000 pretty much maybe 900 and change
-
02-06-2008, 06:30 PM #7
k. just making sure. didn't know if that was normal. i saw a picture of a guy's T/A tach shot and his was idling at 500.
-
02-06-2008, 10:03 PM #8
mine is at 500
-
02-06-2008, 10:34 PM #9
-
02-07-2008, 09:01 AM #10
so back to question of where is the idle screw??
i'm sure it affects gas mileage.
-
02-07-2008, 09:24 AM #11
500 rpm
-
02-07-2008, 09:25 AM #12
when mine was 1000 rpm it said high idle (SES code) had a vacuum leak.
-
02-07-2008, 09:31 AM #13
- Join Date
- Aug 2005
- Location
- Crystal Lake IL
- Age
- 47
- Posts
- 2,517
Pewter- 2001 Camaro Z28 M6
your IAC, TPS and MAF effect idle, a dirty airfilter or dirty fuel filter can kill it too.
if your idling at 800 steadily, I would not worry about.
I idle between 900-1300 because of my cam and letting the car warm up.
-
02-07-2008, 09:33 AM #14
- Join Date
- Aug 2005
- Location
- Crystal Lake IL
- Age
- 47
- Posts
- 2,517
Pewter- 2001 Camaro Z28 M6
the idle screw is on the throttle body.
I suggest using a multi-meter when adjusting, you can cause an SES code to go off. Plus when using the multi-meter you can make sure your TPS is working fine.
does your gas mileage seem lower then normal and does the car sometimes feel as if its is pulling on its own?
-
05-23-2008, 03:28 AM #15
Idle issue
Hey guys i seem to be having the same issue. I did a head/cam/Lt install as well. Car fired right up...I had to adjust the screw about 1/2 turn and it idled around 900-1000. It still seemed to want a little more so i upped to 1000-1100.Car started right up and would idle perfect.. No pedaling. I sent my Comp of for a tune till i can get to the dyno.. I had them adjust my idle speed. I put it back in and it wants to idle around 900 again.. WTF.. I adjusted the screw another 1/2 turn back to wear it was good.. The CPU keeps correcting it and goes back to 900 after 5 mins or so.. I hear there is a way to unplug the TB and turn the ignition to on turn back off and plug the TB back in.. This is supposed to set the TB position to Zero.. But i tried this and it doesnt work.. I guess i going to have to call somebody. By the way, using a volt meter, where do i take reading at.. Also what are you reading, milli, dc, or OHMs,, thanks, KDKenny D
2002 SS LE #2505
-
05-23-2008, 05:13 AM #16
When I had my SS dyno tuned, the tuner said the idle screw has a tendency to loosen up and might move a couple of threads so once he got everything set right he put some Loctite on it to keep it where he set it at.
2002 SLP Camaro SS
Onyx Black
http://www.gmhightechperformance.com/features/0901gmhtp_2002_chevy_camaro_ss/index.html
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
idle issues... idle high. unplugged tps runs good?
By okiels1 in forum Firebird / WS6Replies: 2Last Post: 12-31-2016, 03:36 AM -
Help: intermittant rough idle, off idle hesitation
By Matto4785 in forum General HelpReplies: 1Last Post: 09-21-2009, 05:12 AM -
SES light on after normal idle for about 30 min.
By MSTZ TA in forum General HelpReplies: 11Last Post: 01-27-2009, 06:34 AM -
Help: Is Eratic Idle normal after removing PCM?
By SVG210 in forum General HelpReplies: 10Last Post: 08-08-2008, 02:54 PM -
Help!! About to buy an 01 Vette w/ 550hp. smokes at idle, normal? **Video inside**
By marcus769 in forum General HelpReplies: 14Last Post: 04-23-2006, 05:05 PM
Bookmarks