Ls6 Intake Manifold

[GUSHER]

WHAT EXTRA WOULD I NEED TO PUT THIS MANIFOLD IN MY CAMARO 98 I ALREADY HAVE THE 80 MM BBK Throttle BODY BUT I DONT KNOW IF I CAN USE IT IN TIS MANIFOLD
ANY COMMENTS
THANKS

[SeVeReDiStOrTiOn]

You'll need the manifold ant the coolant pipe..along with the 2 plugs. Here's a link with the instructions and the part numbers are at the top of the page. http://ls1howto.com/index.php?article=5

You'll also need to get rid of the EGR...unless you buy the slp manifold or do the conversion yourself. When you take the EGR out you'll need to get the codes tuned out also...otherwise you'll always have the SES light on.

[Roastem]

You'll need the manifold ant the coolant pipe..along with the 2 plugs. Here's a link with the instructions and the part numbers are at the top of the page. http://ls1howto.com/index.php?article=5

You'll also need to get rid of the EGR...unless you buy the slp manifold or do the conversion yourself. When you take the EGR out you'll need to get the codes tuned out also...otherwise you'll always have the SES light on.

+1

That pretty much sums it up. You can put the intake on there without the coolant plugs and pipe, but it is not recommended. To do that, you will need to take pliers and break off the ribbing under the LS6 manifold. There is a big ass coolant pipe that the LS1 intake is molded to avoid, but the LS6 is flat under the bottom. Breaking the ribbing will give about an 1/8th inch of clearance, which is just barely enough.

[GUSHER]

Thanks
Very Help Full