Results 1 to 4 of 4
Thread: LQ9 question.......
-
06-02-2011, 08:19 PM #1
- Join Date
- Jun 2011
- Location
- Auburn,Wa
- Posts
- 2
Blue- 1979 Chevy K5 Blazer
LQ9 question.......
Hello, I am going to be getting a LQ9 take-out motor tomorrow and was wanting to try and see if I can make it run on a test stand before I tear it down and get it machined. Is this easily possible or is it a pipe dream?
-
06-02-2011, 09:24 PM #2
I've done it and seen it done before. As long as you have the computer, starter, fuel supply and what not hooked up it'll work.
-
06-11-2011, 08:51 PM #3
- Join Date
- Jun 2011
- Location
- Auburn,Wa
- Posts
- 2
Blue- 1979 Chevy K5 Blazer
Happen to know what pins on the computer need power and all that? I have the complete fuse block and I think all the ecm harness
-
06-13-2011, 09:04 AM #4
I don't remember any of that stuff. Its been way to long since I did it and I had the help of an ASE master tech so that helped alot. I would try googling it or if you have access to ALLDATA it should have all the wiring diagras you'll need.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
speedometer question + top speed question
By Krazy351w in forum General HelpReplies: 7Last Post: 06-21-2007, 05:51 PM -
HPIII question (not the same old question)
By slims00ls1z28 in forum Computer & TuningReplies: 5Last Post: 06-01-2007, 04:55 PM -
97 Bird Headlight question also engine noise question
By Zapper2003 in forum General HelpReplies: 2Last Post: 12-13-2006, 03:03 AM -
Speedometer question, RPO question
By acrylicophobia in forum Firebird / WS6Replies: 12Last Post: 11-02-2006, 07:08 AM -
Sex Question spinoff- PORN QUESTION
By egaian in forum Almost Anything GoesReplies: 77Last Post: 07-26-2006, 03:07 PM
Bookmarks