how to install fuel press in engine bay?? have PIC

[greatwhiteZ28]

well for my tripple guages ill be added a fuel pressuse guage but how does the engine bay hook up ( whats everything ill need) and could i still run one on my guage pod.

http://www.pichostonline.com/uploads/6632d24a57.jpg

[mrr23]

in this pic, you can see where the electric sender is hooked into the fuel rail on the driver's side. it is a -4AN female with a 1/8" NPT hole and -4AN male. now, you can get a -4AN cap to block off the make side. looks like you have the fitting. electric gauge is safer, as you don't have fuel coming into the passenger compartment.

[greatwhiteZ28]

thanks again, bought just out of curieosity can that guage still be under the hood ? and i will difinly by the electric guage

[mrr23]

yes it can. instead of using a -4AN cap, just screw that one onto the fitting i explained about that i use.

[greatwhiteZ28]

thanks, do you have a wet or dry kit??

[mrr23]

in the pic is a dual wet kit at that time.

[greatwhiteZ28]

soo thats a V fitting on the fuel rail?? is that both fuel ??

[mrr23]

yes. split off to two fuel solenoids. here's pic of the engine bay

[greatwhiteZ28]

sorry, as you probly read im really new to NX, just trying to soak in as much as i can. thanks

now how does the 2nd stage feel??ccurieouis example(( 300 motor+150 s 1 then + s 2 = almost 600 HP

please explain.

i know im far from doing the dual shot but just asking

[mrr23]

never got it to work past the 1/8 mile. kept falling over. even did a dry/wet combo to no avail.