Which Gauges????

[1slowbusa]

I have a 3 gauge pillar pod and i already have an AEM Wideband. What should i fill the other two holes with????

Any opinions

Thanks

[SMWS6TA]

What mods you have and what are your plans?


With your yr I'd recommend a water temp gauge. 98's are the only yr that they have an accurate gauge while all following yrs do not.

For me I'm getting a fuel pressure gauge, AEM wide band, and oil temp and a Tach with shift light.

[1slowbusa]

These are the mods.
I dont think i am missing anything.

G5x3 cam 112LSA
AFR 205 heads 62cc chambers
Cometic .040 head gaskets
Comp Cam 921 valve springs
Texas speed 7.4 push rods
Yella terra lifters
Rollmaster double roller timing chain
Ls6 ported oil pump
Monster stage 5 clutch with tick master cylinder, stock slave cylinder
Ls6 Intake
Fuel injector connection 42# injectors
NGK TR6 spark plugs
SLP air lid
1/7/8 TSP headers
TSP Y-Pipe with high flow cats
Stock exhaust after Y-pipe except for 3’’ electronic cutout

[SMWS6TA]

nice setup.....are you planing on running NO2?

[1slowbusa]

I thought about it but i fly cut the pistons 100 thousands on the intake to allow for a bigger cam (G5X4) in the future. Will NO2 affect the flycutting?

[35th-ANV-SS]

Your wide band already covers fuel pressure for the most part. I really don't see what else you "need" since you're a M6. If you were an A4, I would say trans temp gauge. If you don't trust the OEM gauges, get an oil pressure gauge.

[cammed goat]

Water temp and oil pressure if not a vacuum gauge.

[1slowbusa]

Thanks for all the replies.

[tatertot91]

Water temp and oil pressure if not a vacuum gauge.

Agreed, about all you need

[cruzincamaro]

What mods you have and what are your plans?


With your yr I'd recommend a water temp gauge. 98's are the only yr that they have an accurate gauge while all following yrs do not.

For me I'm getting a fuel pressure gauge, AEM wide band, and oil temp and a Tach with shift light.

I hear that a lot. Is it the gauge or the sending unit that is inaccurate?

[SMWS6TA]

Not sure which one. On my 98 I have actual temp readings and on the others I believe it is a generic color code like green = >160 yellow = 180* range, and red = 220* range. <<I'm not 100% sure that is what it looks like, because to be honest I haven't looked at a 00-02 temp gauge in about 5 yrs.


This thread below can tell you most of the differences between the 98-02 yrs.

http://www.ls1.com/forums/f6/differe...y-years-27512/

[35th-ANV-SS]

Temp gauge on the 01/02's has interval markings. There is 5 tick marks. Starts at 100 degrees, middle is 210 degrees and ends at 260 degrees.

[cruzincamaro]

I have a 3 gauge pillar pod and i already have an AEM Wideband. What should i fill the other two holes with????

Any opinions

Thanks

I been looking for a gauge pod too. Where did you get yours?

[35th-ANV-SS]

I have a 3 gauge pillar pod and i already have an AEM Wideband. What should i fill the other two holes with????

Any opinions

Thanks

I been looking for a gauge pod too. Where did you get yours?

- Auto Meter Triple Pillar Pod,2-1/16" - Part #43-12213

That's the one I bought.