electric cutout? advice/questions.

**charliebrown1321** · 10-21-2005, 01:18 PM

I'm really thinking about getting an electric cutout for my 99 t/a. If I do this, the car is just going to be aftermarket lid + cutout, for probably quite some time because I work a hourly job, and don't have a lot of money to work with since i'm going back to school soon. If anyone has any clips of what it will sound like that'd be awesome, or advice if its not a good thing to do, etc.

Also if anyone can reccommend a good shop or private installer for this in the texas DFW area i'd really appriciate it, and should I buy the cutout online and take it to the shop, or have them get it for me.

**Sarge** · 10-21-2005, 01:32 PM

About any shop (automotive reapir/muffler) can put em on....just ground the switch and grab a key switched lead....cut em out and weld the cutouts in.....loud as shit.....wont hurt nor help anything...just loud as shit

**charliebrown1321** · 10-21-2005, 01:39 PM

haha thats pretty much what I'm looking for. I won't have money for serious modding till i'm out of school in about 2 years, but I had full exaust in my camaro *R.I.P* and I miss the sound of it so bad.

The reason I asked about shops is cause I went through hell on my 97 'maro, the exaust shop I went to did a REALLY shoddy job (after 2 weeks there were 3 leaking or broken welds) so I was hoping someone could reccomend a place they knew was reputable

**SeVeReDiStOrTiOn** · 10-21-2005, 02:09 PM

not sure if marco muffler is national or not....but they always do a good job on my vehicles

eh...just looked it up..their only local

**02z28ls1** · 10-21-2005, 02:17 PM

It depends more on who is doing the work rather than the shop-I mean if the guy doing the welding is crappy it doesn't matter where he is working at.On the other hand if the guy is a good welder he could be working at any shop-you just need to find him.