Results 1 to 3 of 3

Cam Position Sensor Ground

This is a discussion on Cam Position Sensor Ground within the General Help forums, part of the LSx Technical Help Section category; Im getting a P0342 Cam Position Sensor Low Voltage after installing my new Trans. I Know we damaged my Oil ...

  1. #1
    LoudMouth SStriker's Avatar
    Join Date
    Jul 2006
    Location
    Westminster/Sykesville, Maryland
    Age
    28
    Posts
    512

    Red
    2000 Trans Am

    Cam Position Sensor Ground

    Im getting a P0342 Cam Position Sensor Low Voltage after installing my new Trans. I Know we damaged my Oil pressure sending unit reinstalling the intake and i had to replace that. I really dont want to pull the intake back off if i dont have too. I have a feeling this code is being caused by a bad ground. Does anyone know where the ground for the Cam Position sensor leads too?

  2. #2
    Senior Member
    Join Date
    Jul 2005
    Location
    Jacksonville, FL
    Posts
    2,725
    Don't think it has a dedicated ground, just 3 wires - possibly the PNK/BLK wire going to the PCM? Maybe this will help, you can click on the diagram to enlarge it. www.gearchatter.com/viewtopic8873.php

  3. #3
    LoudMouth SStriker's Avatar
    Join Date
    Jul 2006
    Location
    Westminster/Sykesville, Maryland
    Age
    28
    Posts
    512

    Red
    2000 Trans Am

    I figured it out. one the connectors where the EGR is was not clipped all the way. the wire ran to this connector... good thing i didnt pull the intake and replace the sensor.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. crank position sensor
    By tbias in forum General Help
    Replies: 24
    Last Post: 12-26-2008, 10:40 AM
  2. cam position sensor
    By general23cmp in forum General Help
    Replies: 3
    Last Post: 02-20-2008, 06:47 PM
  3. Crank Position Sensor
    By ARM5280 in forum External Engine
    Replies: 1
    Last Post: 09-09-2007, 03:58 PM
  4. Cam sensor position error??
    By zero_proto in forum Computer & Tuning
    Replies: 7
    Last Post: 01-06-2007, 07:20 PM
  5. Crankshaft position sensor help
    By landon00 in forum General Help
    Replies: 2
    Last Post: 02-20-2006, 08:10 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •