Results 1 to 13 of 13

ASR Question...

This is a discussion on ASR Question... within the General Help forums, part of the LSx Technical Help Section category; okay so i don't know if my car is equipped with asr or not.. there is no switch next to ...

  1. #1
    Member BlinkFan0072's Avatar
    Join Date
    Feb 2006
    Location
    Asheville
    Age
    27
    Posts
    67

    Red
    1998 Z28

    ASR Question...

    okay so i don't know if my car is equipped with asr or not.. there is no switch next to the fog light switch.. but yesterday i did a long ass burnout and my "low trac" light came on and the burnout kinda weakened up i heard if you had it you can pull a fuse and it will turn it off.. but i don't even know if i have it.. looked in the manual and all it said was if it's equipped you'll have a switch and then it showed the light.. so no help there.. does anyone know

    also i changed my oil and wanted to reset the oil change timer.. and i held the trip odometor button for like a minute.. nothing happend so need some help there too

    thanks!

  2. #2
    Senior Member ninobrn99's Avatar
    Join Date
    Aug 2003
    Location
    Honolulu HI
    Age
    33
    Posts
    2,486

    Pewter
    all bore 370 Trans Am

    if you dont have a switch that says ASR, you dont have it. Turn the key all the way foward before turning the car over, hold the trip reset button until the oil light flashes.

  3. #3
    Member BlinkFan0072's Avatar
    Join Date
    Feb 2006
    Location
    Asheville
    Age
    27
    Posts
    67

    Red
    1998 Z28

    thanks for the asr answer.. but i held in the button and no oil light flash.. to make sure i held it in for a minute.. no flash.. any help?

  4. #4
    Senior Member ninobrn99's Avatar
    Join Date
    Aug 2003
    Location
    Honolulu HI
    Age
    33
    Posts
    2,486

    Pewter
    all bore 370 Trans Am

    press it a few times, then hold it down. Is the key turned all the way foward with the car off?

  5. #5
    Senior Member SeVeReDiStOrTiOn's Avatar
    Join Date
    Aug 2005
    Location
    Roseville, CA
    Posts
    8,164

    05 Wrangler
    00 Z28 sold :-(

    Quote Originally Posted by BlinkFan0072 View Post
    okay so i don't know if my car is equipped with asr or not.. there is no switch next to the fog light switch.. but yesterday i did a long ass burnout and my "low trac" light came on and the burnout kinda weakened up i heard if you had it you can pull a fuse and it will turn it off.. but i don't even know if i have it.. looked in the manual and all it said was if it's equipped you'll have a switch and then it showed the light.. so no help there.. does anyone know

    also i changed my oil and wanted to reset the oil change timer.. and i held the trip odometor button for like a minute.. nothing happend so need some help there too

    thanks!
    Besides the asr switch...another way to tell is if you have 2 cables going to your throttle linkage on your TB. If you have traction control and cruise control you'll have one cable for the throttle. If you have cruise but no traction you'll have two.

    far as the oil you have to have the key in the on position but don't start the car...hold the trip down and it should reset after like 15 seconds

  6. #6
    SUPREME member-oderator oneBADDz's Avatar
    Join Date
    Nov 2005
    Location
    Lost in Texas
    Age
    33
    Posts
    2,683

    Custom Slate Blue
    99 B4C

    You can just turn the key to on and press the gas to the floor three times, then turn the key off. Both methods work to reset the oil light in these cars.

  7. #7
    Member BlinkFan0072's Avatar
    Join Date
    Feb 2006
    Location
    Asheville
    Age
    27
    Posts
    67

    Red
    1998 Z28

    okay thanks... i'm wondering if my oil light might be burnt out.. cause it's not showing a light..anyway thanks i guess i don't have asr.. two cables to the tb and i have cruise..

    my next question is when i do a burnout and the low trac light comes on.. is it doing anything to comprimise my performance??

  8. #8
    Junior Member
    Join Date
    Sep 2005
    Location
    Lancaster, PA
    Age
    35
    Posts
    98

    black
    2000 Z28 (sold)

    The low trac light could be your abs for some reason.

  9. #9
    Likes twisty roads bene's Avatar
    Join Date
    May 2006
    Location
    England but from TX
    Posts
    803

    Light Pewter Metallic
    2K Camaro Z28

    Quote Originally Posted by BlinkFan0072 View Post
    anyway thanks i guess i don't have asr.. two cables to the tb and i have cruise..
    I have both ASR, cruise control and I have two cables at my TB.

  10. #10
    Senior Member SeVeReDiStOrTiOn's Avatar
    Join Date
    Aug 2005
    Location
    Roseville, CA
    Posts
    8,164

    05 Wrangler
    00 Z28 sold :-(

    Quote Originally Posted by bene View Post
    I have both ASR, cruise control and I have two cables at my TB.
    You shouldn't...maybe someone put the asr switch in there to look like you have it You the original owner?

  11. #11
    SUPREME member-oderator oneBADDz's Avatar
    Join Date
    Nov 2005
    Location
    Lost in Texas
    Age
    33
    Posts
    2,683

    Custom Slate Blue
    99 B4C

    Quote Originally Posted by bene View Post
    I have both ASR, cruise control and I have two cables at my TB.
    It doesn't work that way, something is up

  12. #12
    Likes twisty roads bene's Avatar
    Join Date
    May 2006
    Location
    England but from TX
    Posts
    803

    Light Pewter Metallic
    2K Camaro Z28

    Quote Originally Posted by oneBADDz View Post
    It doesn't work that way, something is up
    You shouldn't...maybe someone put the asr switch in there to look like you have it You the original owner?
    Sorry guys. I must've been on drugs when I said that and seeing double yeah, I only have one cable.

  13. #13
    Member jmhvenom's Avatar
    Join Date
    Oct 2005
    Location
    Cincinnati, OH
    Age
    31
    Posts
    821

    Silver
    2002 Z28

    The weakening of your burnout was probably the tires warming up and grabbing... I have the ASR switch because i ordered it... just wired it up so it lights up... was thinking of using it as somekind of switch but couldnt figure out the wiring

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •