Results 1 to 2 of 2

acess to troque converter bolts

This is a discussion on acess to troque converter bolts within the General Help forums, part of the LSx Technical Help Section category; i am about to pull my auto trans out of my 1999 trans am. how do i get to the ...

  1. #1
    sonson44
    Guest

    acess to troque converter bolts

    i am about to pull my auto trans out of my 1999 trans am. how do i get to the troque converter bolts?

  2. #2
    Junior Member Pete2k_Z28's Avatar
    Join Date
    Jul 2005
    Location
    nj
    Age
    38
    Posts
    39
    Pull out the single wire connector going into the oil pan (that's the oil level sender). Then remove the two 14mm bolts holding in the starter. Pull out the starter and let it hang on it's wire, it's ok if you're careful. Take a 10mm, 1/4" drive ratchet with a 3" extension and remove the black plastic flywheel cover the starter passes through. Then get a boat load of extensions, put a ratchet between the K-member and the sway bar, put the socket in the allen bolt, and loosen with all your might. Helps to have a 1/2" ratchet on the crank pulley with a 24mm socket and a 3" extension to turn the flywheel to it's next position, or possibly to have a buddy brace the rotating assembly against you turning the converter bolts.


Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Members who have read this thread: 0

There are no members to list at the moment.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •