Page 1 of 2 12 LastLast
Results 1 to 20 of 35
  1. #1
    Junior Member
    Join Date
    Apr 2006
    Location
    Louisiana
    Posts
    18

    pewter metallic
    2002 SS Camaro

    Roof Defect/Bubbles

    I have a 2002 SS Camaro and I started getting this small roof bubbles, I have been informed that this is a defect that the glue has started to come thru the fiberglass. The Body shop states I have to have the entire roof taken off which means cutting it off completing and replacing it.. Anyone have any info on this.. Has anyone had this replaced? What was the outcome.. I am scared to have my car cut on. I am out of my extended warranty, is this a factory Defect? I am calling the Dealership in the morning.. The service manager was out today.

    Thanks in advance for your feedback..

    Susan

  2. #2
    Junior Member
    Join Date
    Feb 2006
    Location
    GARDEN GROVE, CA
    Age
    51
    Posts
    95

    BLACK
    2002, CAMARO Z28

    There's a technical service bulletin on this. It calls for replacing the whole roof which I had done. It turned out fine.

  3. #3
    38 of 139 PontiacFan's Avatar
    Join Date
    Jul 2005
    Location
    Kearney, NE
    Posts
    931

    Black
    2001 Pontiac

    Search "Roof Bubbles", there's a ton of info here, as mentioned above.
    Find a copy of the TSB, Technical Service Bulletinm & take it to your dealer. If you are polite enough, they might just fix it without any cost to you.
    Some dealers do, some don't.
    And they don't really have to 'cut' into the car. It's a big plastic panel that is simply gluded on. Pull it off, clean up the area, glue on the newly painted panel. Rarely takes more than a couple hours.
    Had mine replaced after it was over the 36k mile warranty. But still in the 3yr window.
    Good Luck, ...

  4. #4
    Junior Member
    Join Date
    Apr 2006
    Location
    Louisiana
    Posts
    18

    pewter metallic
    2002 SS Camaro

    Roof Bubbles Gone Wild

    Thanks for the feedback. I brought my car to the dealership today and he said that it would be repaired and covered 100%! My faith in Chevrolet has been restored, I plan on purchasing an 09 Camaro to share the garage (and I hope there is a High Performance Engine option)

  5. #5
    Impounded MikeSomething's Avatar
    Join Date
    Dec 2005
    Location
    Old Bridge, NJ
    Age
    44
    Posts
    1,419

    Pewter Metallic
    '00 Z/28

    Mine's a 2000 w/ no warranty. Don't think the dealer would do anything for me honestly.

  6. #6
    Senior Member JonB's Avatar
    Join Date
    Sep 2006
    Location
    Florida
    Age
    40
    Posts
    1,455

    Black
    2005 GTO

    Quote Originally Posted by her ss View Post
    Thanks for the feedback. I brought my car to the dealership today and he said that it would be repaired and covered 100%! My faith in Chevrolet has been restored, I plan on purchasing an 09 Camaro to share the garage (and I hope there is a High Performance Engine option)

    Glad to hear there taking care of you. I really should take mine in to see if they will do mine. My roof panel seems to just keep getting worse.
    05 PBM GTO
    Cold Air Inductions CAI,
    Relocated IAT with omega,
    Slp Predator tune,
    Flowmaster axle back with H pipe,
    Custom tuned TCM.
    BC Racing coil overs


    Sold 01 z28

  7. #7
    Junior Member Jeremiah's Avatar
    Join Date
    Jun 2006
    Location
    Mustang Ok.
    Age
    50
    Posts
    69

    NBM
    98 Mecham TA #4 of 14

    Quote Originally Posted by MikeSomething View Post
    Mine's a 2000 w/ no warranty. Don't think the dealer would do anything for me honestly.
    Six years from the "original" purchase date under Corrosion protection.

  8. #8
    Moving forward. Pyromaniacal's Avatar
    Join Date
    Apr 2006
    Location
    Utah
    Posts
    167

    Blue/Yellow/White
    95 T/A 383

    My '02 WS6 with 77k miles just got them about 2 months ago, they just appeared one day.. how much does the operation to get them fixed cost usually?

    I doubt that I have any sort of warranty help here either..

  9. #9
    Member screamin chicken's Avatar
    Join Date
    Jul 2005
    Location
    sc
    Age
    55
    Posts
    516

    Black, Red, Silver Jade
    00 WS6,95 Ta, 69 R code

    I am one of the unlucky ones my 2000 WS6 has them and since 2003 with only 22,xxx miles GM would not do anything to mine.

  10. #10
    Junior Member
    Join Date
    Apr 2006
    Location
    Louisiana
    Posts
    18

    pewter metallic
    2002 SS Camaro

    I went straight to the dealership, not the one I ordered it from but one that I was referred to by a good friend who is an excellent painter for an auto body shop. The manager of didn't even call GM. He looked at my car saw I took excellent care of it and sd he has seen this in the past and would cover it. Sd he couldn't cover it under the 6 yr corrosion warranty for it was not rust. But as Chevy he would cover it. I was in his office approx 30 mins. He ordered my parts that day. It is factory defect. GM should cover everyone's repairs! As I have been reading in other posts before mine was posted, it seems it just has to do w/the dealership whether they cover it or not. I would try a diff dealership esp since you have low miles.

  11. #11
    The Anti-Rice PureSShp00's Avatar
    Join Date
    Apr 2007
    Location
    Longview, tx
    Age
    42
    Posts
    872

    Black
    2000 Camaro SS Coupe M6

    so they have to replace the whole top peice? i have a 2000 ss and it has the lil bubbles as well...but it looks like the clear coat...im guessing from the sun and the heat?

  12. #12
    Junior Member
    Join Date
    Apr 2006
    Location
    Louisiana
    Posts
    18

    pewter metallic
    2002 SS Camaro

    they have to replace all 4 panels of the roof. The heat makes the glue come thru the fiberglass of the roof panels.. Painting will not fix this issue, the bubbles will just come back thru, is what I have been hearing.

  13. #13
    Junior Member blackmagic00's Avatar
    Join Date
    Sep 2007
    Location
    atlanta,ga
    Posts
    26

    black
    2000 z28 camaro

    hmmm thats interesting...i have the same problem on my car...not only the roof but i notice that my spoiler has bubbles forming. anyone else have this problem yet?

  14. #14
    SLS SENN13's Avatar
    Join Date
    Oct 2007
    Location
    Leesburg, Georgia
    Posts
    25

    Maple Red Metallic
    2000 Trans Am

    My 2001 Camaro had the same bubbles and was repainted three times before the dealership decided to replace the panel. The panel was replaced and all was fine. The body shop guy actually painted my whole car (after market hood, wing, and ground effects were primer), said he would write it all off as warranty work.

  15. #15
    Member Mike's TA's Avatar
    Join Date
    Nov 2006
    Location
    Austin, TX
    Age
    41
    Posts
    880

    Black
    99 Trans Am(sold)

    Quote Originally Posted by SENN13 View Post
    My 2001 Camaro had the same bubbles and was repainted three times before the dealership decided to replace the panel. The panel was replaced and all was fine. The body shop guy actually painted my whole car (after market hood, wing, and ground effects were primer), said he would write it all off as warranty work.
    Lucky Bastard!!!

    j/k I know I won't be able to get mine fixed for free. I'm just not that lucky. Even though I agree that GM should fix it since it's a manufacturers defect. Thing is. I'm probably going to repaint my hole care eventually anyways and mine does not look that bad yet. Barely even noticeable.

  16. #16
    SLS SENN13's Avatar
    Join Date
    Oct 2007
    Location
    Leesburg, Georgia
    Posts
    25

    Maple Red Metallic
    2000 Trans Am

    From what the body shop manager told me, the dealership gets pais from GM for warranty work performed. He said that he would tell GM that the bubbles were on most of the body panels and that way the body shop wins and so do I. haha!

  17. #17
    Junior Member
    Join Date
    Apr 2006
    Location
    Louisiana
    Posts
    18

    pewter metallic
    2002 SS Camaro

    Roof Bubbles- Roof replaces have gap!

    Update: Well I took my car into the dealership for the top replacement. When I picked the car up the top looked beautiful but there was a gap between the windshield moulding in only the driver and passenger side corners. I asked the Bodyshop Manager what happened and he said that my mouldings must have shrunk. (it was lined up perfectly before I brought the car in) I might also point out that the windshield was not removed to install the top, they slid the top in under the existing moulding. Well I new this didn't sound reasonable but decided to replace the glass and see what would happen.

    I brought the car home and had the windshield replaced but the gap is still there. The man that replaced the windshield installed a new moulding and slid the windshield up as high as it would go. I brought the car back to the body shop and they don't know what the problem is. They want to attempt to change out the moulding again to fill in the gap. It looks to me that the top is actually about 1/4 short on both corners (driver and passenger side) and this would explain the gap. My question is this…..

    1) Is there a quality control issue possibly with the top being short in just the two corners?
    2) Is it possible that the top wasn't installed properly? The manager said that there is only one way that the top will fit like there is some kind of guide for it to fit.

    3) Any bodymen out there that have experience changing the tops on these cars that might be able to offer a suggestion?
    I asked the shop (a Chevrolet Dealership) to measure the old top so that we could compare it to the length of the new top but they had already shipped it back to Chevrolet. Any information will help. Has everyone else had success with their top replacements or have there been issue's?

    Thanks

  18. #18
    Junior Member RaulSS's Avatar
    Join Date
    Aug 2005
    Location
    Miami
    Age
    46
    Posts
    8

    Artic White
    1999 Camaro SS

    I had the same issue but my gap ran from the front of the roof to the back. I noticed because my car is white and underneath the roof is white. So I just painted the little visible gap that I had in black so now you really can't notice. When I took it back to the dealer they told me that the molding would settle and the roof what drop and cover the gap. That never happened and I just left it like that. I'm pretty sure that the only way to fix it is to replace the roof again.

  19. #19
    Junior Member
    Join Date
    Apr 2006
    Location
    Louisiana
    Posts
    18

    pewter metallic
    2002 SS Camaro

    Does anyone know if it is possible for them to have put the top on a little to far back or are there some type of alignment pegs etc that will not allow it to be moved? The body shop manager said there is only one way it will fit but I question this because he doesn't want to have to change out the panel again.. From my standpoint the roof panel was put on incorrectly OR the panel is about 1/4" short on both corners.
    Thanks

  20. #20
    38 of 139 PontiacFan's Avatar
    Join Date
    Jul 2005
    Location
    Kearney, NE
    Posts
    931

    Black
    2001 Pontiac

    Is this a full roof panel, or just the strip from b-pillar to b-pillar?
    This sounds confusing.
    If the car has t-tops, this panel has nothing to do with your windshield alignment.

    Does your car have t-tops or not?

    I don't believe it could be set too far back.
    As then it would intereferre with the rear hatch when it opens.

Page 1 of 2 12 LastLast

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Help: Roof Panel paint bubbles
    By mdcrabbie in forum Appearance Section
    Replies: 25
    Last Post: 06-14-2009, 09:02 PM
  2. Need Help - Sail Panel/Roof With bubbles ?
    By 99CANADAHAWK in forum Firebird / WS6
    Replies: 21
    Last Post: 02-14-2008, 03:17 PM
  3. Roof Bubbles
    By tcordray in forum Camaro / SS
    Replies: 17
    Last Post: 07-15-2007, 06:00 PM
  4. paint bubbles on roof
    By Scanlamp in forum Rocky Mountain Members
    Replies: 10
    Last Post: 03-07-2007, 05:29 PM
  5. Failed roof to roof jump
    By ss~zoso~ss in forum Multimedia Section
    Replies: 6
    Last Post: 10-20-2006, 08:55 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •