Results 1 to 20 of 60
-
11-24-2012, 10:57 AM #1
- Join Date
- Jan 2010
- Location
- texas
- Posts
- 1,623
silver- 2000 formula
My COMPLETE LED changeover in PICS !
it took me some time but I have finally finished my LED changeover......it took so long cuz LEDS aint cheap !!! the hardest part was picking the right bulb..........some bulbs that were suggested did not end up being what I really wanted so back to the drawing board I went....
-
11-24-2012, 10:59 AM #2
- Join Date
- Jan 2010
- Location
- texas
- Posts
- 1,623
silver- 2000 formula
did the dash lights last......but you will see them first
the plastic piece is held on by these clips......just pull it straight out.........and finagle it in evey angle to clear the steering column
-
11-24-2012, 11:01 AM #3
- Join Date
- Jan 2010
- Location
- texas
- Posts
- 1,623
silver- 2000 formula
i had 2 clips that broke off..............dont know if it was me or old age.......the left side clip at the bottom by the steering column is a PITA !!! I removed it to ease re-installation
-
11-24-2012, 11:03 AM #4
- Join Date
- Jan 2010
- Location
- texas
- Posts
- 1,623
silver- 2000 formula
the fog light switch is another PITA.....pull the wire out to get to the connector and disconnect.......it will be wrapped up in tape
-
11-24-2012, 11:04 AM #5
- Join Date
- Jan 2010
- Location
- texas
- Posts
- 1,623
silver- 2000 formula
i replaced the bulb in the headlight switch too
-
11-24-2012, 11:07 AM #6
- Join Date
- Jan 2010
- Location
- texas
- Posts
- 1,623
silver- 2000 formula
the bulb is right on top but I ended up having to remove the whole assembly AND disassembling it to put the new bulb in.....the plastic on the new bulb housing was a tad larger causing interference
- - - Updated - - -
old bulb
-
11-24-2012, 11:09 AM #7
- Join Date
- Jan 2010
- Location
- texas
- Posts
- 1,623
silver- 2000 formula
LED........NEO 3 mm
-
11-24-2012, 11:12 AM #8
- Join Date
- Jan 2010
- Location
- texas
- Posts
- 1,623
silver- 2000 formula
look ma.......no gauges.....unscrew the tilt lever and remove.......makes it a whole lot easier.......and again.....it takes some finagling to get that puppy out.......but it will come out
- - - Updated - - -
-
11-24-2012, 11:13 AM #9
- Join Date
- Jan 2010
- Location
- texas
- Posts
- 1,623
silver- 2000 formula
- - - Updated - - -
-
11-24-2012, 11:15 AM #10
- Join Date
- Jan 2010
- Location
- texas
- Posts
- 1,623
silver- 2000 formula
you will need 8 bulbs.......5 for the main lighting.......2 green for turns......1 blue for highbeam
- - - Updated - - -
the stock 194 in the bulb holder
-
11-24-2012, 11:16 AM #11
- Join Date
- Jan 2010
- Location
- texas
- Posts
- 1,623
silver- 2000 formula
green LED in holder......the bulb holders are hard to turn but they do turn to remove
-
11-24-2012, 11:19 AM #12
- Join Date
- Jan 2010
- Location
- texas
- Posts
- 1,623
silver- 2000 formula
I initially got these LEDs in red due to a recommendation from Sommers......but I got one that was bad out of my 5......( check them BEFORE you install !! ) and ended up using some others that I had...........the ones I was going to use before had that recommendation
-
11-24-2012, 11:22 AM #13
- Join Date
- Jan 2010
- Location
- texas
- Posts
- 1,623
silver- 2000 formula
all back in............there are 4 bolts.........7mm...........holding it in
- - - Updated - - -
this pic does not do it justice.....it is REALLY bright
-
11-24-2012, 11:25 AM #14
- Join Date
- Jan 2010
- Location
- texas
- Posts
- 1,623
silver- 2000 formula
i put a red LED in here......it is brighter than stock........but the red is actually washed out with the red lens behind the overlay.....I am going to go with a white LED to see if it looks better
- - - Updated - - -
the green LEDs for turn are BRIGHT !!!!
-
11-24-2012, 11:26 AM #15
- Join Date
- Jan 2010
- Location
- texas
- Posts
- 1,623
silver- 2000 formula
i had a white LED in the shifter but changed it out to red......MUCH better in red
-
11-24-2012, 11:27 AM #16
- Join Date
- Jan 2010
- Location
- texas
- Posts
- 1,623
silver- 2000 formula
the door works better with a white LED
- - - Updated - - -
-
11-24-2012, 11:28 AM #17
- Join Date
- Jan 2010
- Location
- texas
- Posts
- 1,623
silver- 2000 formula
white LED in the HVAC
-
11-24-2012, 11:31 AM #18
- Join Date
- Jan 2010
- Location
- texas
- Posts
- 1,623
silver- 2000 formula
white LEDs in the mirror...........VERY bright
- - - Updated - - -
went with a flat panel in the rear.............waaaay brighter than the stock style LED
-
11-24-2012, 11:33 AM #19
- Join Date
- Jan 2010
- Location
- texas
- Posts
- 1,623
silver- 2000 formula
LEDs for the tails
- - - Updated - - -
end light
-
11-24-2012, 11:34 AM #20
- Join Date
- Jan 2010
- Location
- texas
- Posts
- 1,623
silver- 2000 formula
main
- - - Updated - - -
changed out to FULLY electronic flashers
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
COMPLETE REDO of PCV System(pics writeup)
By JoshieDoom in forum General HelpReplies: 49Last Post: 03-01-2010, 03:50 PM -
Baer Eradispeed install complete...PICS
By cascade in forum Suspension and HandlingReplies: 3Last Post: 06-18-2008, 11:28 PM -
LS6 intake changeover question
By RARON455 in forum External EngineReplies: 6Last Post: 05-17-2008, 07:58 AM -
Mods complete! PICS!
By grandkodiak in forum LT1Replies: 13Last Post: 01-25-2007, 04:01 PM -
complete t56 swap - o/r/y - ravin' muffler **PICS**
By bmf8586 in forum Parts For Sale / TradeReplies: 11Last Post: 07-28-2006, 11:38 AM
Bookmarks