Fuel Rail Cover Help!

[CWW17]

Could someone help me out with the modifications I need to make for a proper fitment on my 98 TA. Thanks in advance!

They are 97-98 Corvette FRC's

What should I use to cut, where to cut and do I need to do anything special to do this?

[SOMSS]

Get a hold of a Dremmel and mark out where your fuel line runs and cut out the appropriate notch.

[PontiacFan]

Search, search, search, ...
Simply look at all the photos all over the web & the forums.
Figure it out. Dremel, Jigsaw, coping saw, ..., Whatever it takes, ...
How about one of those miracle cutting tools that came out a couple years ago that lets you cut thru drywall, ceramic tile, ...,What the hell are they called again?!? Sorry, off on a tangent, ...



(FYI SOMSS, I don't think the fuel line notch is the problem. At least he has the right start with the dual notch covers from the 97-98 Corvette.)

[cobrahunter]

To make my fuel rail covers fit right I had to make some adjustments to the stock Corvette covers.

Here's an image of a set of fuel rail covers from Afterthoughtsauto with the adjustments already made. The modifications I made were very similar. An additional cut that you can't see very well is for the throttle body cable on the passenger-side cover.

[EVL LS1]

with mine i had vette frc's with one opening on the side.. had to cut a 2nd... just went slow and marked where i needed then used a dremel tool











cept i cut the line after i had painted them then went back over with silver again... looked perfect when done

[cobrahunter]

Yeah, the cut I made was a little bit smaller.

[SOMSS]

Nice job guys, sooner or later I'm going to have to do this mod for my SS.

[CWW17]

great job evl... looks look great... thanks guys

[cobrahunter]

Here's my setup...