wiring up an e-cutout

**kebie05** · 12-24-2007, 02:59 PM

does anyone know of a write up of an e-cutout install. i will be installing in the i pipe near the rear axle. i hear there is an opening back there that is god for running the wires up through. i am looking for a step by step write up if there is one. thanks

**Zapper2003** · 12-24-2007, 05:26 PM

I don't know about a specific writeup for our cars, but QTP's website has the generic wiring info for their cutouts I think. *shrugs* I'd think it'd be pretty simple.

**kebie05** · 12-24-2007, 07:53 PM

i am not good at all with wiring stuff up. exhaust shop doesnt do all that do they?

**Speedy_Gonzales** · 12-24-2007, 08:16 PM

pm Orion he can tell you how he did his

**Speedy_Gonzales** · 12-24-2007, 08:31 PM

ok took me about 15 minutes to find this post from orion about wiring the cut-out

Quote:
Originally Posted by blackhawk01

how do you guys run your wires?? do you have to drill a hole in the car?

there's a grommet right below the passenger seat you can pass the wires through. I pulled the passenger seat out and took the kick plate off so I could run the wires under the carpet and up to the center console to my switch. I then ran from there to the fuse box and crimped on a spade connector and hooked it to the aux. spot in the fuse box.