Wiring sub/Amp

**horns011** · 10-26-2009, 03:56 PM

I'm planning on putting a box with 2 10's in the rear cargo well with an amp in the driver side wheel well. Does anyone have an easy way to run the rca and power cables for the amp? Any suggestions would be appreciated.

**noxside** · 10-26-2009, 07:30 PM

I ran all of mine through the plastic on the drivers side, and the power cable through the passenger side plastic, just pull out, tuck wire, put back.

**devildogws6** · 10-26-2009, 07:51 PM

Thats what i did too its actually pretty easy kinda time consuming, just keep rca cable and power cable seperate otherwise get a buzz noise most the time lol

**chocos_ls1** · 10-26-2009, 09:12 PM

^^^^^^agree what kind of amp and subs are u puttin in?

**chocos_ls1** · 10-26-2009, 09:16 PM

by da way when u run the power tru the passenger side engine firewall,unbolt the ecu move it alittle. and ul c a hole where to put the wire tru,its the easiest spot i found.

**horns011** · 10-27-2009, 12:41 PM

Alright thanks for the help.
Im putting in 2 polk mm1040's with a memphis 500w amp

**35th-ANV-SS** · 10-27-2009, 01:09 PM

I would remove the seat belt bracket along the plastic floor trim and put the wiring tucked in. This will alleviate the chance of you screwing into a wire when you put the floor cover back in.

Or, tape the wire to the underside of the trim panel so it will be out of the way of the screw holes.