This is a discussion on Speaker wiring within the Stereo and Electronics forums, part of the General Help category; I have the monsoon and I have already replace the HU with a pionner in-dash and I'm trying to wire ...
02-10-2006, 07:15 AM #1
- Join Date
- Dec 2005
- Charlotte, NC
- 2000 WS6
I have the monsoon and I have already replace the HU with a pionner in-dash and I'm trying to wire up the speakers. I'm putting in infinity 63.7 and I have crossovers but since the amp already has crossovers built-in, should I just make a wiring harness out of the old speakers? I'm not planing on ever putting the old speakers back in so I don't care about messing them up. Any suggestions?
02-10-2006, 07:25 AM #2
- Join Date
- Jul 2005
- OHIO Go Buckeyes!
- '07 Trailblazer LT
Don't bother using any of the factory wiring. Run all new wires.
You'll most likely need to use your passive crossovers with the speakers. Most amps only have a high pass crossover for use with installs that also have a subwoofer setup (which use amps with a low pass crossover for the sub).The White Rascal SOLD
Crank up the drums, crank up the bass,
Crank up my Les Paul in your face!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Ed Blown Vert in forum AAG ArchivesReplies: 4385Last Post: 02-09-2006, 01:55 PM
By MSTZ TA in forum Stereo and ElectronicsReplies: 3Last Post: 12-29-2005, 08:44 AM
By 34v6needhelp in forum Stereo and ElectronicsReplies: 3Last Post: 12-14-2005, 08:56 PM
By Nicbmann in forum Stereo and ElectronicsReplies: 2Last Post: 10-04-2005, 02:32 PM
By billscamaros in forum Stereo and ElectronicsReplies: 1Last Post: 08-23-2005, 03:51 AM