Results 1 to 2 of 2

Cam Cost

This is a discussion on Cam Cost within the GTO forums, part of the Vehicle Specific category; Did anyone replace there cam? if so how much did it cost with labor and everything? thanks...

  1. #1
    Join Date
    Jun 2007
    Annville PA

    2004 gto

    Cam Cost

    Did anyone replace there cam? if so how much did it cost with labor and everything?

    2004 GTO silver/red int.
    SLP Loudmouth I Exhaust
    Pacesetter Ceramic Coated Headers
    3" Mid pipes (no Cats)
    K&N CAI
    SLP Heavy Duty Sway Bar SLP Sway Bar Bushings
    GMM Ripshift
    125 shot of nitrous HSW
    nittos D/Rs 555R
    Hp Tune 13.03 @ 109 mph (without nitrous, GMM Ripshift, and Nittos)

  2. #2
    Junior Member
    Join Date
    Oct 2006
    south of the border

    2004 GTO

    Depends on the cam / cam package you go with. I went with a custom ground cam package with the cam, springs, pushrods, seals, retainers, etc and that ran $925. Some speed shops offer off-the-shelf packages for around $600.

    Also, while doing the cam it's a good idea to change your timing chain, to an under drive pulley, and to a high-volume oil pump. These parts will cost you around $400-500. If you shop around on eBay and such you can find some pretty good deals.

    The install cost me $850, including the oil pump, and I had it done at HPE in Houston. The tune was another $425.

    If your car is an automatic, you'll want to install a stall coverter.
    2004 GTO M6
    K&N CAI
    Kooks LTs w/ Cats, SLP LM 1
    CCW SP500 18X10, 18X8.5, Kuhmo 275/35, 245/40
    GMM Ripshift
    Powerbond UD Pulley
    FTI Rebel TQ Cam

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. FINAL Info On What Cam I Should Go With!!!
    By NeeD4SpeeD in forum Internal Engine
    Replies: 48
    Last Post: 09-02-2008, 02:38 PM
  2. PORTED LS1 Heads/Comp Custom Grind Cam Made 450WHP 404WTQ FS
    By EliteZ in forum Parts For Sale / Trade
    Replies: 7
    Last Post: 03-23-2007, 09:55 AM
  3. Denver Cam Help????????
    By Cornfed in forum Rocky Mountain Members
    Replies: 9
    Last Post: 01-08-2007, 03:47 PM
  4. Advise about a CAM
    By SSwt00SS in forum Internal Engine
    Replies: 13
    Last Post: 05-14-2006, 06:36 AM
  5. Cam Spectrum
    By Sarge in forum General Help
    Replies: 0
    Last Post: 12-05-2005, 03:43 AM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts