Results 1 to 2 of 2

rear main seal

This is a discussion on rear main seal within the LT1 forums, part of the Vehicle Specific category; on a 96 t/a do you just pry out the old rear main seal and tap in the new one? ...

  1. #1
    Junior Member Y2K_WS6's Avatar
    Join Date
    Feb 2009

    2000 Trans Am WS6

    rear main seal

    on a 96 t/a do you just pry out the old rear main seal and tap in the new one? first time at this. the felpro came wit a set of gaskets that i have no idea where the go.
    Last edited by Y2K_WS6; 06-07-2009 at 12:04 PM.

  2. #2
    Senior Member JaycenK's Avatar
    Join Date
    Nov 2008

    1997 Camaro Z-28

    Rear main is a one piece on these engines so replaceing it is not that easy. I think you have to remove everything from the back of the crank and then there are some bolts that hold the rear seal in and you will have to remove the pan and I think the rear bearing cap but I'm not possitive on the cap.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. rear main seal
    By 00z28bubba in forum General Help
    Replies: 7
    Last Post: 11-20-2008, 10:35 PM
  2. Replies: 4
    Last Post: 01-08-2007, 04:14 AM
  3. Replacing Rear Main Seal?
    By shlby123 in forum Manual Transmission
    Replies: 1
    Last Post: 11-20-2006, 11:57 AM
  4. Junkyard Rear End
    By SleeperZ28 in forum Drivetrain
    Replies: 3
    Last Post: 11-14-2005, 08:55 AM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts