Results 1 to 1 of 1
Thread: Bosch fuel injector question
-
09-13-2006, 07:29 PM #1
Bosch fuel injector question
I had my fuel injectors replaced with Bosch 36# units when I had the STS turbo installed. It ran fine for a while (~2000 miles). Then the fuel pressure regulator failed. I pulled the rails and injectors to replace the regulator myself. The operation was a success, except now my injectors are falling into the intake manifold and out of the fuel rails. I have tried new orings, lubricating the orings, everything I could find on the forums. I then researched some more, and discovered that the original injectors have a groove cut near the top for a clip that holds it to the fuel rail. The Bosch do not have such a groove. Is there a solution out there? I am really frustrated at this point and would appreciate some advice.
Thanks in advance.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
fuel injector question
By 1998 T/A in forum External EngineReplies: 14Last Post: 03-11-2015, 11:15 AM -
Fuel injector question
By RichWS6 in forum Firebird / WS6Replies: 6Last Post: 04-09-2014, 12:42 PM -
Fuel injector question
By SOMTRANSAM in forum Almost Anything GoesReplies: 21Last Post: 08-12-2012, 11:33 AM -
red bosch gen 3 30 injector tables
By bsomm in forum Computer & TuningReplies: 2Last Post: 10-14-2009, 09:38 AM -
Fuel Injector Question
By rbrack in forum External EngineReplies: 1Last Post: 02-28-2006, 06:53 PM
Bookmarks