Page 2 of 2 FirstFirst 12
Results 21 to 24 of 24

lid rubing?

This is a discussion on lid rubing? within the Firebird / WS6 forums, part of the Vehicle Specific category; Two-year old thread johno, ... But yes, it will fit good. And one of the problems with the aftermarket SLP ...

  1. #21
    38 of 139 PontiacFan's Avatar
    Join Date
    Jul 2005
    Kearney, NE

    2001 Pontiac

    Two-year old thread johno, ...
    But yes, it will fit good.

    And one of the problems with the aftermarket SLP lid was installation.
    Make sure the front lip of the lid is BEHIND the lip of the base.
    And SLP did some redesign of the lid from the old embossed-outward 'SLP', to the newer hot-stamp with white paint SLP lid.
    And the added gasket doesn't help any either. Many of the aftermarket filters had that foam gasket adder, like the K&N. Then the clips don't stay closed, & the lid rubs, etc., etc., etc, ...

    johno, where can we see photos of yer 'Black&Gold'?

  2. #22
    Custom Painter/Tech Customta98's Avatar
    Join Date
    May 2009
    Plainwell, Mi

    Flame Red / Orange Custom
    1998 Trans Am

    I have the same problem with it not seating well in the rear of the lid so I used a razor blade to cut the bellows to fit better then I adjusted the radiator cover so that it sits better keep the 4 bolts loose but not pulled out adjust it then tighten it down it should help some but it not perfect. hope this helps.

  3. #23
    Bullet Boy Same ol Situation's Avatar
    Join Date
    Dec 2008
    Cincinnati, Ohio
    2002 CETA m6

    if you get a smooth bellow your going to have to cut a bit off so the lid will set all the way back.

    when your lid as tight as it will be be it should have a somewhat "underbite look" that should prevent clamps from falling off too

    never had any trouble with the lid rubbing on the hood?

  4. #24
    formally 01 T/A 0verkill's Avatar
    Join Date
    Jul 2007
    San Diego ca

    "Arrest Me Red"
    2001 trans am

    what they sead.

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. SLP vs Granatelli MAF sensor
    By amitc31100 in forum External Engine
    Replies: 18
    Last Post: 08-24-2010, 08:48 PM
  2. FS: SLP Airbox Lid for '98-'02 LS1 F-body
    By vtirocz in forum Parts For Sale / Trade
    Replies: 1
    Last Post: 09-26-2007, 07:19 PM
  3. SLP lid...tried for a day and took it back off.
    By stanger88 in forum External Engine
    Replies: 31
    Last Post: 05-26-2007, 09:40 AM
  4. My CETA air lid
    By BANDITCAR in forum Appearance Section
    Replies: 27
    Last Post: 04-19-2007, 01:11 PM
  5. SLP Air-Box lid wont fit?
    By GlowStickgl in forum General Help
    Replies: 8
    Last Post: 01-11-2006, 10:41 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts