Removing the licence plate holder...

**99_LS1** · 12-18-2006, 08:45 PM

Not sure if this is where this should be put, and sorry if this has been asking a million times already, tried searching for a while but not finding what I'm looking for.

Is there a way to take the holder off and still be able to put it back on? The pins/clips that hold it in need to be pryed out, right? I probably will be getting a new grille altogether soon but until then, I was just wondering if I could do that. Thanks for any info.

**2000SS4273** · 12-19-2006, 08:26 AM

The license plate holder is attached by three screws. Just remove the license plate and then you will see the three screws that go thru the grill and into the front bumper. If you want to replace the grill, the best way is to remove the front bumper to gain access to the clips that hold the grill on to the bumper. If you try to remove the grill without removing the bumper, you may damage the bumper by prying the grill off. I know others on this forum have done it this way, but I did it the right way by taking the bumper off. I hope this helps.

**A~NICE~CAR~IS~A~NICE~CAR** · 12-19-2006, 01:30 PM

I had the front license plate, what i did was just pull that thing right off! now i have 3 tiny holes in my grille where the 3 screws were. I wanted a new grille anyways! lol

**OnEbAdReDSS** · 12-19-2006, 01:31 PM

U guys are lucky... mine is rivetted in the grill... and laso my grill is broken.. oh well time to get a new grill!

**A~NICE~CAR~IS~A~NICE~CAR** · 12-20-2006, 09:44 AM

oh shit! did i say screws! lol dude mine was rivitted also!
like i said i just pulled that bitch off! and have the three little holes were they were in the grille, only visible from up close, but still lol