Results 1 to 20 of 22
Thread: Parts Parts Parts!
-
06-07-2010, 04:21 PM #1
Sub box with subs and misc. Parts!
Custom made box and two 12" Rockford fosgate subs, in working order, had been using these in my yukon since I switched to a stealth box, but now have a truck and these won't fit. I will consider mailing if buyer is interested, but it will probably cost a bit due to weight. ($150 pick-up)
Dimensions of the box are 38" x 16 1/4" x 8 1/4"
upper radiator support and airbox/ lid and baffles (SOLD)
Stock MAF (SOLD)
NBM t/a hood with struts and latches. Paint is in good condition, no chips. ($200)
Right turn signal housing (Sold)
Stock Torque Arm ($15 pick up, $48 shipped)
Stock Front calipers/brake pad bracket, brake hoses, retainer clips, ceramic pads. (SOLD)
Stock rotors ($50 shipped)
Driver's side mirror with motor, brand new, unpainted...brand new, never used ($80 shipped)
LS1 camshaft ($45)
853 heads/springs ($60 pick up or $95 shipped)
LS1 pushrods ($20 shipped)
LS1 chain ($20 shipped)
LS1 oil pump ($30 shipped)
LS1 valley cover/gasket and bolts (SOLD)
Subthump box for 2 10" BOX ONLY (SOLD)
LS1 stock thermostat, no issues, removed for lower temp thermostat (SOLD)
One Bosch 13111 O2 sensor, brand new, in box. (SOLD)
SLP LS6 intake manifold with EGR provision and INCLUDES MAP sensor (SLP P/N: 30041) I am also including mounting bolts for the intake, which did NOT come with the kit from SLP. Does NOT include LS6 coolant lines. (SOLD)
LS1 intake with coolant lines. (SOLD)
Stock LS1 throttle body ($75 shipped)
Prices are negotiable, feel free to pm me with offers.Last edited by peterlawl84; 07-01-2010 at 07:13 AM.
-
06-07-2010, 04:22 PM #2
SLP LS6 intake manifold with EGR provision and INCLUDES MAP sensor (SLP P/N: 30041) I am also including mounting bolts for the intake, which did NOT come with the kit from SLP. Does NOT include LS6 coolant lines. (SOLD)
Last edited by peterlawl84; 06-18-2010 at 04:07 PM.
-
06-16-2010, 08:20 AM #3
- Join Date
- Jun 2010
- Location
- San Antonio
- Posts
- 1
- iTrader
- 0
Silver- 2000 Trans Am Ws6
interested in those mirrors. i have silver ws6 black rimms. those r black right?
-
06-16-2010, 01:52 PM #4
-
06-16-2010, 04:50 PM #5
- Join Date
- May 2010
- Location
- Ohio
- Posts
- 35
- iTrader
- 0
Black- 2000 T/A WS6
i might be interested in the intake if you still have it
-
06-16-2010, 05:06 PM #6
Intake is still available, I have had several potential buyers, but they fail to come up with the payment.
Here are a couple close up pics of the EGR.
-
06-17-2010, 06:35 AM #7
- Join Date
- Aug 2009
- Location
- Virginia Beach, Virginia
- Posts
- 145
- iTrader
- 0
Black- 2000 Pontiac Trans Am WS6
I am curious about the the EGR hook up, do you have directions for it or is it self-explanatory? Do you take PayPal? Any idea what the coolant lines go for?Thanks.
Scott
-
06-17-2010, 10:19 AM #8
I did not do the initial install of the intake...had a shop do it, so I do not have the directions anymore. Y ou might have to trim the end of the stock EGR tube, I am sure you can get install directions from SLP too, but the shop said it was a pretty simple install. But when I removed the EGR, it seemed pretty self-explanatory...that brass nut (with the aluminum piece in the pic) slides over the stock EGR tube and then tighten it down. The aluminum block off plate pops out of the brass piece, I just used that as a block off rather than buying a new capped piece.
The LS6 coolant lines...I have seen for around $50 last I checked (but not absolutely sure), but many have used the LS1 lines with the LS6 intake, just need to remove the ribs on the bottom of the intake.
And I prefer paypal and can get the intake shipped the day of or following day that I receive payment. Price includes paypal fees and insurance.
-
06-17-2010, 04:30 PM #9
Guys, I am not interested in low ball offers. I am not scrapped for cash so I am not going to accept a low offer just because it was made. If you are going to make an offer, make it reasonable.
Thanks
-
06-18-2010, 10:06 AM #10
SLP LS6 intake sold.
-
06-22-2010, 03:40 PM #11
VC pending.
-
06-23-2010, 02:07 PM #12
valley cover sold.
-
06-24-2010, 05:15 PM #13
calipers sold
-
06-25-2010, 10:20 AM #14
- Join Date
- Jun 2010
- Location
- Ohio
- Posts
- 15
- iTrader
- 0
- 2006 Pacifica
Just to be sure, that is a stock hood, not Ram Air, etc. and would fit just fine on a 99 Base model.
-
06-25-2010, 11:03 AM #15
-
06-25-2010, 12:22 PM #16
yep, stock, non-ram air hood. It would fit the v-6 as well.
-
06-25-2010, 07:42 PM #17
turn signal housing pending.
-
06-26-2010, 03:47 PM #18
Turn signal housing sold.
-
06-30-2010, 06:35 PM #19
sub box with 2 fosgate 12" subs added.
-
07-14-2010, 06:13 AM #20
- Join Date
- Jun 2010
- Location
- Ohio
- Posts
- 15
- iTrader
- 0
- 2006 Pacifica
any idea how much shipping on the hood would be to 43054?
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
November 2011 Chevy High Performance Parts - Parts Rack
By Ed Blown Vert in forum Camaro / SSReplies: 0Last Post: 09-15-2011, 09:10 AM -
Late Model Pontiac Performance Parts - SEMA Show - 2007 New Parts Tech Guide
By Ed Blown Vert in forum Firebird / WS6Replies: 0Last Post: 02-13-2007, 10:10 PM -
PARTS PARTS PARTS...tires, LCAs, relocation brackets, etc.
By BackinBlack02SS in forum Parts For Sale / TradeReplies: 4Last Post: 02-28-2006, 03:41 PM -
PARTS PARTS PARTS...tires, wheels, sway bar, G-Tech, etc.
By BackinBlack02SS in forum Parts For Sale / TradeReplies: 22Last Post: 01-29-2006, 01:36 PM -
FOR SALE: T-top conversion Hugger ORANGE parts, ebony interor parts!
By camaros4ever in forum Parts For Sale / TradeReplies: 7Last Post: 11-21-2005, 12:17 PM
Bookmarks