(1) REPAIRED 215CC Trick Flow cylinder head GenX C

[9t8z28]

For sale is (1) 215CC, CNC ported GenX Trick Flow cylinder head. It is a bare cylinder head that had the pushrod holes bored for a larger pushrod. Unfortunatly (2) of the pushrod holes were cut to deep and broke through the intake port. The heads have been repaired, pressure tested and flow tested. They still flow the factory cfm. The repair is only about a 1/4" on each port. As a matter of fact, I saw the port before it was repaired and it was basically a pin hole. The shop that repaired it is very reputable and guarantees it to function as it was originally intended to. This head is brand new except for the repairs done to it.
If you are interested, I can PM you the serial# that is cast into every TFS to identify it and its production date.

If you want a set of these heads, this is a good way to knock of a good chunk of change off of the final price. I gained 60 RWHP with just these heads using a stock cam!

I am asking $550 O.B.O. + $15 shipping

(Serious inquiries only. Please do not waste my time with LOW BALLING)

If you are interested, PM me and I will send you back my cell#. I am tired of all of the PM's. I can give you all the info you need in 5 minutes on the phone instead of 20 PM's back a forth.








[IMG][/IMG]

[bowtieguy02SS]

warranty?

[9t8z28]

warranty?

There are no warrantys on cylinder heads, but I guarantee it will work or you get your money back. I have a high trader rating, never ripped anyone off and I intend to keep it that way.

[bowtieguy02SS]

what supporting equip. will i need? head bolts included, length of push rods? very interested..

[9t8z28]

what supporting equip. will i need? head bolts included, length of push rods? very interested..

No, head bolts are not included. I would recommend ARP studs if it is FI but you can use stock replacements for NA.

You will need a longer pushrod and they run about $110. I forget what length. I will look it up for you.

Trick Flow recommends using a roller rocker since it has special valve guides.

[9t8z28]

You will need a 7.5" pushrod. Stock pushrods are 7.3"

[bowtieguy02SS]

ok ty and you will stand by your product?

[9t8z28]

ok ty and you will stand by your product?

Yes, I will stand by the product. If you put it on and there is some issue, I will refund your money provided that you ship the head back to me.

[natzke4]

So this sale is only for 1 head and not 2?

[9t8z28]

So this sale is only for 1 head and not 2?

Yes, (1) head is for sale.

[9t8z28]

Come on peeps, make me an offer. I need this gone.

[9t8z28]

bump....

[9t8z28]

New pics

Here are some more pics as per request.

I have numbered all of the intake ports in the following pics which help to describe the following:



Below two pics are the repaired ports




The rest of the pics show that none of the intake ports were touched and therefore needed NO repair




I have numbered all of the pushrods holes in the following pics which help to describe the following:



The following pic shows that #2 hole was machined and is now repaired.



The following pic show that #4 hole was machined and now repaired.


The rest of the pics show that non of the pushrod holes were touched and therefore needed NO repair

[9t8z28]

SOLD!

[side2000]

nice. it was killin me to see ya struggle to sell that thing.

[9t8z28]

nice. it was killin me to see ya struggle to sell that thing.

Thanks