Things that make you go hmmm.

[pajeff02]

In the last week or so, I have changed the oil in our Suburban, freed up a frozen toe adjuster on the back and swapped out an inner and outer front tie rod on the wife's Stratus, changed the transmission fluid and filter, an O2 sender, the front differential fluid and transfer case fluid, and replaced all the front and rear driveshaft u-joints on the Durango, and also installed an electric brake controller in the Suburban this evening.

Tonight, I found this on the garage floor next to the driver side lift column. I have not a friggin' clue what it is or where it came from.

[blackSS01]

In the last week or so, I have changed the oil in our Suburban, freed up a frozen toe adjuster on the back and swapped out an inner and outer front tie rod on the wife's Stratus, changed the transmission fluid and filter, an O2 sender, the front differential fluid and transfer case fluid, and replaced all the front and rear driveshaft u-joints on the Durango, and also installed an electric brake controller in the Suburban this evening.

Tonight, I found this on the garage floor next to the driver side lift column. I have not a friggin' clue what it is or where it came from.

Piece off the lift....pin?

[024mula]

It looks like a tension pin that inside a rubber mallet.

When you were working on your cars did you use a rubber or plactic mallet?

Other than that I would'nt know what it is.

[pajeff02]

The only pin on the lift that I know of is for the lowering handle -- that is intact. I used my dead blow hammer on the Durango to beat the Y-pipe out. However, it is a solid molded hammer with no pieces. There was no oil or fluid on the pin and also no discernible wear marks that might give me a clue.

[blackSS01]

The only pin on the lift that I know of is for the lowering handle -- that is intact. I used my dead blow hammer on the Durango to beat the Y-pipe out. However, it is a solid molded hammer with no pieces. There was no oil or fluid on the pin and also no discernible wear marks that might give me a clue.

Hmmmm

[big hammer]

In the last week or so, I have changed the oil in our Suburban, freed up a frozen toe adjuster on the back and swapped out an inner and outer front tie rod on the wife's Stratus, changed the transmission fluid and filter, an O2 sender, the front differential fluid and transfer case fluid, and replaced all the front and rear driveshaft u-joints on the Durango, and also installed an electric brake controller in the Suburban this evening.

Tonight, I found this on the garage floor next to the driver side lift column. I have not a friggin' clue what it is or where it came from.

looks like a human hand too me. how have your typing skills been since you found it?

[ORION WS6]

Looks like the rods that are inside the u-joints, was it oily?

[pajeff02]

Looks like the rods that are inside the u-joints, was it oily?

The roller bearings in a u-joint are hardened steel pins. This is made of brass or something very similar. As stated, it was not oily.

[blackSS01]

Maybe a pin on the tranny pan?!?! I know our oil pans have a pin in them during assembly but they need to be drilled out

[pajeff02]

Maybe a pin on the tranny pan?!?! I know our oil pans have a pin in them during assembly but they need to be drilled out

No such thing that I know of on the Durango.

[blackSS01]

No such thing that I know of on the Durango.

Maybe a piece of the diff

[GTP231]

Derek stopped by and played a prank

[pajeff02]

Maybe a piece of the diff

If it was from the diff, I would expect to find it in the drain tub on my oil tank and not the floor.

Derek stopped by and played a prank

Distinct possibility.

[blackSS01]

No clue then!

[blackbirdbrain89]

looks to me like an ing cylinder lock pin

[blackSS01]

looks to me like an ing cylinder lock pin

Good guess

[cuervo25_1]

WTH is wrong with you people? Don't you know a finnigin pin when you see one?

No clue what it is, might be from something not pertaining to anything you did..........wait a minute did you do anything to the monte steering column? that looks like the piece for the horn.

[suede]

Yea ill be back over to get that tommorow..... dont ask questions you dont wanna know the answer to.... lmao

[suede]

server fail lol

[cuervo25_1]

server fail lol

more like Suede Fail