This is a discussion on methanol injection within the Forced Induction forums, part of the LSx Technical Help Section category; Hello I am a F-body methanol injection specialist Any ? , or need info or help , let me know...
03-16-2007, 11:16 PM #1
I am a F-body methanol injection specialist
Any ? , or need info or help , let me know
03-18-2007, 12:59 PM #2
Anyone need help or have questions let me know
03-19-2007, 07:25 PM #3
What would it do to my car if I just hooked it up on there without tuning for it? If you even need a tune for it? I have the STS turbo on my car with the Devils Own meth kit on it right now. We didn't need it for the tune I did because I'm only running 5 p.s.i.(wanted to keep it safe) Would it help me or what?
03-19-2007, 11:53 PM #4
Tuning in a progressive methanol injection system on a Dyno Jet will yeild more power , and allow you to add more timing even if you keep the boost at 5-6 psi Your turbocharged motor should be leaned out on injector and add in the methanol to make up for the Fuel taken out. This will add extra protection, from the higher octang found in methanol, also the cooling benefit of the intake air inlet charge.
Ok if you already have your car tuned for 5psi then adding a methanol injection system will richen up your A/F ratio. I was running my LS1 like this for about a year, it will work fine just make sure you have a good A/F wide band gauge in your car so u can see how much your methanol system is riching up your A/F as you turn it up and tune it.
It realy depends on where your A/F ratio is on injector , once you know that you can adjust you methanol system to add methanol , depending on how rich you want to run her,
Let me know your A/F on injector, maybe i can walk you through a tune.
Also is your methanol system Progressive? and fully tunable?
Last edited by LS1injection; 03-19-2007 at 11:55 PM. Reason: added info
03-20-2007, 12:00 PM #5
- Join Date
- Nov 2006
- las cruces nm
- 1999 z/28
is there a special type of washer fluid i can use? i have the coolingmist adjustble kit and sts turbo kit but i want to make sure the meth is working correctly before running 8psi. thanks
03-20-2007, 03:49 PM #6
I use VP M1 race methanol straight, best in the industry!
03-22-2007, 03:09 AM #7
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By blackTA6585 in forum General HelpReplies: 12Last Post: 01-27-2007, 06:12 PM
By crazycat in forum Forced InductionReplies: 1Last Post: 08-20-2006, 03:26 PM
By tuske427 in forum General HelpReplies: 0Last Post: 07-27-2006, 06:56 PM
By Trouble maker in forum Almost Anything GoesReplies: 14Last Post: 03-09-2006, 04:50 PM
By stonebreaker in forum Forced InductionReplies: 15Last Post: 03-02-2006, 07:57 PM