Results 1 to 5 of 5
-
11-25-2006, 09:27 AM #1
- Join Date
- Oct 2006
- Location
- Indy
- Posts
- 5
Black- 1998 Trans Am Ram Air WS6
All T/A's with HID's please come!
Im looking to get an H4 HID Kit and then buying the H4 sealed beam conversion kits but my question is how do i connect the stock wiring to the HID wiring since its made for an H4 socket and our car's obivously dont have an H4 socket... i want to do it this way because it will only cost me about $200 instead of $300... Any thoughts?
-
11-25-2006, 07:19 PM #2
- Join Date
- Oct 2006
- Location
- Indy
- Posts
- 5
Black- 1998 Trans Am Ram Air WS6
Come on.. i know tons of you guys have HID's...
-
11-25-2006, 07:48 PM #3
- Join Date
- Oct 2005
- Location
- Tejas
- Posts
- 19
You just e-mailed me on the H4 wiring. Just so you know my car is a LT1 so the wiring will be different than what your doing with a LS1. I purchased a H4 wiring conversion kit for $15. I then used a voltmeter to figure out what wires were low/high beam and ground. It did not take to long and I even soldered and heat-shrink'd all my connections.
-
01-30-2007, 08:44 PM #4
-
01-31-2007, 11:57 AM #5
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks